User manual LERVIA KH 1150

[. . . ] 3 halogen light bulbs) Pull chain for the light Pull chain for changing the speed Blades (5 pcs. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. The minimum distance from the tips of the blades to the floor must be 2. [. . . ] Step 4: First tighten both screws evenly at the same time until hand-tight, then screw them in tightly with the screwdriver. 4b Installing the short Extension Rod: After pulling the cable through (s. 4a, part-step 1) you must first carry out the following assembly step 5. 5 Guide the bolts through the upper openings of the extension rod and align them in the middle. Push the support upwards over the bolts, thereby ensure that the safety screw fits into the appropriate recess. Position the cable in the housing such that it will not be squeezed when inserting the light module!1 Screw the blades firmly to the motor housing with 2 screws and washers each (see Fig. 1 Remove the three screws with lock washers from the light module (E). 2 Connect the cable plug for the light modul to the socket on the fan. 3 Insert the light module into the motor housing, making certain that the recess is located under the direction switch (see Fig. 4 Firmly screw in the light module with the three screws and lock washers. 2 Slowly turn the fan for a few complete turns in order to check whether the blades are correctly installed. If the rotation is not smooth and easy, check the screw attachment of the blades. You must make certain that the electrical connection wire is not under power. 2 Remove the screws with the lock washers as well as the transport protection elements. 3 Store the transport protection elements with the screws and lock washers for any future transports. The room ceiling and the screw connection must be capable of bearing a weight of at least 28 kg. Alternatively, you can determine whether the installation plate can be fastened to the lower structure of the subceiling (squared beam, girder) which is capable of bearing more weight, use wood screws. 1Fasten the installation plate (L) to the ceiling with 2 screws and, using the pegs if necessary. Connect the cable plug Connect the cable plugs of the two PE conductors of the fan with the sockets on the installation plate. then connect the wide cable plug of the fan to the socket on the installation plate. 4 Snap the casing (A) onto the installation plate: insert it into the two adjacent bearings and snap it into the opposing spring-loaded bearing (click! [. . . ] Disconnect the fan from the mains network before checking the cable plug. The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. In the case of a warranty claim, please make contact by telephone with our service department. [. . . ]