User manual LAVRY AD10

[. . . ] However, when the CLOCK is set to an external clock mode (WORD or AES), the user is required to supply an external word clock to the BNC connector located on the rear panel. For external clock (WORD or AES) the rate is not user settable; thus it is determined by the signal applied to clock input. Instead, when a valid external clock signal is applied; the proper RATE lamp will indicate the sample rate. When SOUND is set to CLEAR, the user can operate the AD10 at 44. 1, 48. [. . . ] After initialization completes, the function lamps indicate the unit settings. Also, the Level and Gain meters will flash for about 6 seconds to indicate the Gain setting for each channel. Functions In normal operating mode, one LED will be lit for each function, indicating the setting for that function. While in editing mode, a flashing LED will indicate status and function during programming. To enter the Function Mode, press the switch DOWN and hold it in this position until a Function LED starts to flash. Either click the switch DOWN to select the next function (Sample Rate, Clock, Sound, or Bit Depth), or click the switch UP, to select the next available Setting within that function. Please Note- To move more than one step, the switch must be clicked repeatedly; holding the switch down (or up) will not result in the setting changing by more than one step. It will either only change one step, or if held long enough in the applicable direction, will change the mode. To exit Function editing mode, hold the switch DOWN until the LED stops flashing. Alternatively, wait for 6 second (leave the switch untouched) and the unit will automatically exit the editing mode. Gain In normal mode the Level Meter indicate signal from 0dB, or Full Scale, to -13dB digital level. In Gain Mode, this meter will allow you to set up to 13dB's of gain, with each channel being individually controlled. When in Gain Set mode, ignore the minus sign in front of each of the Level values on the meter scale; these values will indicate the amount of Gain you are setting. Please Note- If an input signal is present; the signal level will be displayed in the Gain Set mode at the same time as the Gain setting, so you can see the effect of the gain adjustment on the signal while you are changing it. You may want to mute the input to see the gain indication by itself, especially when you are using the AD10 for the first time. To Enter the Gain Mode, press and hold the switch in its UP position until one of the Left Gain LED's starts to flash, indicating the amount of gain selected for that channel. Click the switch up or down to either increase or decrease the amount of gain. After setting the Left channel, you can adjust the RIGHT channel by holding the switch in the UP position until one of the Right Gain LED's starts to flash, indicating the gain selected for the Right channel. Click the switch up or down to either increase or decrease the amount of gain. To exit Gain Mode, hold the Switch in the UP position until the LED stops flashing. Alternatively, wait for 6 second (leave the switch untouched) and the unit will automatically exit the editing mode. Note: The input connectors can accept either Balanced or Unbalanced signals. [. . . ] Products that are purchased from unauthorized resellers do not have any warranty coverage. A valid purchase receipt or other valid proof of purchase will be required before warranty service is provided. This warranty only covers failures due to defects in materials or workmanship and does not cover damages which occur in shipment or failures resulting from accident, misuse, line power surges, mishandling, maintenance, alterations and modifications of the product, or service by an unauthorized service center or personnel. Lavry Engineering reserves the right to deny warranty service to products that have been used in rental, service bureau, or similar businesses. [. . . ]