User manual LA CROSSE TECHNOLOGY TX7U

[. . . ] #1 for outdoors, #2 for the basement, etc. ) if you have multiple sensors. This will help you determine which temperature, from which outdoor temperature/humidity sensor, you are reading on the indoor display station. Note: Remove batteries from all existing units in operation--including outdoor temperature/humidity sensor units and indoor display stations. When setting up multiple units it is important to insert batteries first into all the outdoor temperature/humidity sensors, and in numeric sequence. [. . . ] Remove the mounting bracket from the outdoor temperature/humidity sensor. Through the 3 screw holes of the bracket, mark the mounting surface with a pencil. Where marked, drill holes into mounting surface using an appropriate size drill bit. Ensure that the screws are flush with the bracket. 5. Snap the outdoor temperature/humidity sensor into place on the mounting bracket. B. MOUNTING WITH ADHESIVE TAPE 1. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. Press firmly into the designated area on the back of the mounting bracket. Remove the protective strip from the other side of the tape, and position the outdoor temperature/humidity sensor in the desired location. MOUNTING USING THE BRACKET AS A STAND The mounting bracket can be used as a stand by simply attaching the bracket to the bottom of the temperature/humidity sensor. Once snapped in place the sensor can then be placed on a shelf, table or other surface where the temperature and humidity measurements are desired. C. III. MAINTENANCE AND CARE 1. Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units 2. Do not use solvents or scouring agents, they may mark the displays and casings 3. Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. SPECIFICATIONS Temperature measuring range Relative Humidity measuring range Transmission interval Transmission frequency Power source Dimensions (H x W x D) -21. 8ºF to 157. 8ºF with 0. 2ºF resolution (-29. 9°C to 69. 9°C) 1% to 99% with 1% resolution) Every 10 seconds in first 3 minutes Every 1 minute thereafter 433. 92 MHz 2 x 1. 5V AA Battery Alkaline recommended 6. 3" x 2. 95" x 2. 2" (160 x 75 x 55mm) IV. V. LIABILITY DISCLAIMER 1. The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any consequences occurring should an inaccurate reading take place. This product is not to be used for medical purposes or for public information. No part of this manual may be reproduced without written consent of the manufacturer. WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. [. . . ] La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. [. . . ]