User manual KRUPS YY8406FB

[. . . ] Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Krups has an ongoing policy of research and development and may modify these products without prior notice. For your safety, this product conforms to all applicable standards and regulations (Low Voltage Directive, Electromagnetic Compatibility, Food Compliant Materials, Environment, …). Do not consume foodstuff that comes into contact with the parts marked with logo . [. . . ] Unlock the appliance using the two safety catches - B on the sides of the appliance - 7. Check that the thermostat - D is in the mini position light - 1 will light up. , then plug the cord into a socket: the red On first use, there may be a slight odour and a little smoke during the first few minutes; this is normal. Pre-heat the waffle maker for 5 to 7 minutes by turning the browness selector to the desired setting - 2. For pre-heating, place the thermostat selector on the chosen cooking position. The green light - 3 will light up when the waffle maker reaches the desired cooking temperature. COOKING Each time the waffle maker is used, wait until the green light comes on before pouring batter into the waffle maker plates. Do not lock the safety catches on the sides of the waffle maker when cooking. Use oven mitts if the tray must be emptied while the appliance is hot and in use - 6. Use a nonstick safe kitchen ustensil to remove the waffle from the waffle maker - 9 The handle will remain cool during cooking - 4. Do not touch the metal body of the waffle maker when the appliance is hot - 5. Tips for better cooking results Each time the waffle maker is used, wipe a small amount of cooking oil onto the waffle plates, then wipe with a soft cloth. The amount of batter should not go past the separation line between the two cooking plates - 8. Increase or reduce the waffle colour to suit your taste, using the 8-position browning indicator. The green light is an indicator that the waffle maker is ready to use. The green light goes out and lights up again regularly during the cooking process, to show that the selected temperature is maintained. Some steam will be produced during cooking cycles, this is normal and allows for a fuller waffle. During the cooking cycle, the top of the waffle maker will drift upward, allowing the waffle batter to fully expand into the plate cavities. Cooking time depends on the kind and the quantity of batter used in the waffle maker. To clean the waffle plates: - once the appliance is cold, brush with a non metal brush to remove any crumbs. [. . . ] Hvis der benyttes forlængerledning: - skal den have et tværsnit mindst på størrelse med ledningens, samt en jordforbindelse; - sørg for at ingen falder i ledningen. Tips for at opnå de bedste resultater for bagning Under hver brug skal man altid smøre vaffeljernets plader før den første bagning med lidt vegetabilsk olie og dernæst tørre dem af med en blød klud. Om en förlängningssladd måste användas : - se till att den har motsvarande diameter och har en jordad kontakt ; - var noga med att se till att ingen kan snubbla över sladden. For din sikkerhet stemmer dette produktet overens med alle gjeldende standarder og reguleringer (lavspenningsdirektiv, elektromagnetisk kompatibilitet, materiell godkjent for kontakt med mat, miljø). [. . . ]