User manual KOMPERNASS KH 4077 STAND HALOGEN FLOODLIGHT

[. . . ] Hand over the manual to whomsoever you pass the appliance on to. -3- IB_KH4077_KO2561_UK. qxd 05. 03. 2007 11:52 Uhr Seite 4 KH4077 Stand Halogen Floodlight Safety instructions Danger of electrical shock!· Only connect the Stand Halogen Floodlight to correctly installed wall sockets having a mains current of 220 - 240 V at 50 Hz. · Unplug the Stand Halogen Floodlight from the socket if you notice any faulty operation and when you decide to clean it. [. . . ] · Never place the Stand Halogen Floodlight in the close proximity of easily inflammable materials. · Never touch the lightbulb with bare hands. Always use a dry lint-free cloth. · Read and observe all safety and operating instructions. -4- IB_KH4077_KO2561_UK. qxd 05. 03. 2007 11:52 Uhr Seite 5 KH4077 · Ensure that the Stand Halogen Floodlight has cooled down before storing it away. Description of the appliance q w e r t y u i o a s d f g ON/OFF Switch Floodlight lever Halogen floodlight Protective grill Knurled screw Crossbeam Telescopic stand Power cable Knurled screw Fixing ring Distributor box Knurled screw Fixing screw Glass cover Mounting the halogen floodlights e on the crossbeam. Insert the knurled screw t with the washer through the hole in the bracket of the halogen floodlight e. Insert the halogen floodlight ewith the knurled screw t in the pre-drilled hole on the crossbeam y. Ensure that the Stoppers are located behind the halogen floodlights e. Insert the knurled screw d first of all through the hole in the distributer box s, then through the hole in the crossbeam y. Now assemble the crossbeam y and the distributor box s with the assistance of the knurled screw d on the telescopic stand u. Adjusting the height of the Stand Halogen Floodlight Loosen the fixing ring a by turning it in an anti-clockwise direction. To adjust the halogen floodlight e, use the knurled screw t, the fixing screw f and the floodlight lever w. Assembly Danger of electrical shock Never insert the plug into an electrical socket until the appliance has been completely assembled. Danger of burns Only touch the halogen lamps when they are in a switched-off and cooleddown condition. Never touch the lightbulb with bare hands, always use a clean and dry lint-free cloth. Opening up the pedestal base To set up the telescopic stand u, loosen the knurled screw, o. Turn the knurled screw o until it is tight. -5- IB_KH4077_KO2561_UK. qxd 05. 03. 2007 11:52 Uhr Seite 6 KH4077 The horizontal position is adjusted in that the knurled screw t is loosened and, with the assistance of the floodlight lever w, it is placed in the desired position. Retighten the knurled screw t when the optimal position has been found. The vertical position is adjusted in that the fixing screw f is loosened and and, with the assistance of the floodlight lever w, it is placed in the desired position. Retighten the fixing screw, f when the optimal position has been found. The retainers should now hold the halogen lamp securely, such that the halogen lamp can no longer move itself. [. . . ] Place a ceramic end on the appropriate retainer. -6- IB_KH4077_KO2561_UK. qxd 05. 03. 2007 11:52 Uhr Seite 7 KH4077 A domestic electrical fuse is defect. Have the Floor Halogen Floodlight checked over by specialists. Service DES Ltd Units 14-15 Bilston Industrial Estate Oxford Street Bilston WV14 7EG Tel. :0870/787-6177 Fax:0870/787-6168 e-mail: support. uk@kompernass. com Kompernass Service Ireland c/o Irish Connection 41 Harbour view Howth Co. Dublin Tel: 087-99 62 077 Fax:18398056 e-mail: support. ie@kompernass. com Disposal Do not dispose of the device in normal domestic waste. [. . . ]