User manual JENSEN VOYAGER VCCS130

[. . . ] If you wear the handset on your body while using the headset accessory, use only the Audiovox supplied carry clip for this product and ensure that the antenna is at least 1 inch (2. 5 centimeters) from your body when transmitting. Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations. Performance: Your transceiver will only achieve its maximum operating range when communicating with other transceivers across open and flat areas or between elevated points. Normally occurring environmental factors such as buildings, trees, terrain and weather, or interference from other radio or electrical equipment, may have adverse effects on the transceiver's effective range. [. . . ] Down Channel/Volume Button (11) In the standby mode, pressing this button will decrease the listening volume. When in function edit mode this button will be used to adjust the unit's settings. Mode Button (12) This button is used to select the various feature settings in the GMRS/FRS or Weather band modes. Holding the MODE button longer than 2 seconds will toggle between the GMRS/FRS and Weather band modes. External Microphone (MIC)/Speaker (SPK)/(CHG) Jack (6) This jack accepts an Audiovox Earbud/microphone connector, or the Charging Adapter connector. For equipment and accessories, refer to Page 7 and/or visit the Audiovox web site at www. audiovox. com Operating Modes and Features GMRS Operation: - From GMRS/FRS standby mode, press and hold the ( ) button for more than 2 second to turn on power . When receiving a call, the BUSY icon appears to indicate the incoming signal. - Press and hold the PTT button (4) to transmit, then speak into the microphone clearly and slowly. The Transmit Signal Level indicator ( ) will display the relative strength of the transmitted signal. 12 128-xxxx 12 of 28 - Release PTT Button (4) to receive. - Communication can only be accomplished when the channel and CTCSS tone frequency of at least two parties are the same. - The CTCSS small segment display will appear next to the main frequency channel on the display if the CTCSS tone frequency function is enabled. Channel Selection In order to communicate with other GMRS units, both transmitting and receiving party must be on the same frequency. Then use the Up and Down buttons to select the desired CTCSS subcode. 15 128-xxxx 15 of 28 - Press the PTT button momentarily to confirm selection of the dual watch channel. The display will now alternate between the primary channel and the dual watch channel just selected. NOTE: Pressing the PTT button during dual watch mode will transmit on the primary channel and suspend dual watch operation for 20 seconds. - Momentarily press the SCAN button to exit the dual watch mode. Key Tone This feature allows the transceiver to sound a confirmation tone whenever the following keys are pressed: Monitor (M) Button, Up/Down Buttons, MODE Button or SCAN Button. To turn the key tones on or off: - From GMRS/FRS standby mode, press the MODE Button 6 times (5 times for FRS) until the Bell ( ) icon flashes, and on or oF appears on the display. - Press the Up or Down Button to toggle the key tone feature On or Off. When the key tone feature is on, the Bell icon appears steady on the display, and the beep tones sound in response to button activation. Roger Beep Tone The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released. This tone alerts the receiving party that the transmission has been terminated intentionally. To enable and disable the Roger Beep tone: - From GMRS/FRS standby mode, press the MODE Button 7 times (6 times for FRS) until the flashing Roger Beep icon ( ) and on or oF appears on the display. - Press the Up or Down button to select the tone on or off as desired. - Press the PTT button momentarily to confirm selection. 16 128-xxxx 16 of 28 Call Ringer Selection Mode The transceiver provides 3 user-selectable call ringer melodies to alert you to an incoming call. [. . . ] · Do not use this device or change its batteries in potentially explosive atmospheres as sparks in such areas could result in an explosion. · Turn your transceiver off wherever posted notices restrict the use of radios or cellular telephones. Facilities such as hospitals may use equipment that is sensitive to RF energy. 20 128-xxxx 20 of 28 · Turn your transceiver off on board aircraft when requested to do so. · Do not place your radio in front of a vehicle's air-bag. [. . . ]