User manual JENSEN VOYAGER JHD1620

[. . . ] JHD1620 AM/FM/RBDS/WB/AUX-IN/iPod Ready/SIRIUS Ready Heavy Duty Radio Installation and Operation Manual Guide d'installation et d'opération JHD1620 CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] After selecting the desired PTY, press the PTY/CAT/MENU button (2) to search the band for broadcasts of this type. "PTY Search" is displayed while the tuner is searching. Auto Seek Tuning Press and hold the TUNE/SEEK >>| or |<< buttons (19, 18) to automatically seek the next or previous strong station. Use the up or down tuning buttons to manually select any of the seven available weather band channels. Preset Stations Six numbered preset buttons store and recall stations for each band. Press a preset button (5-10) to select the corresponding stored station. NOTE: Preset buttons are pre-assigned frequencies in weather band mode. NOTE: Performing a PTY search on "ANY" will Seek Tune and stop on any station broadcasting RBDS, regardless of the program type. 8 JHD1620 Weather Band Operation What is the NOAA Weather Radio/Weatheradio Canada?NOAA (National Oceanic and Atmospheric Administration) is a nationwide system that broadcasts local weather emergency information 24 hours a day via the National Weather Service (NWS) network. network has more than 530 stations covering the 50 states as well as the adjacent costal waters, Puerto Rico, the U. S. Each local area has its own transmitting station and there are a total of seven broadcasting frequencies used. A similar system is available in Canada under the Weatheradio Canada service administered by Environment Canada. Tuning to Weatherband Press and hold the BAND/WB button (15) to access the Weatherband. The indication "WB" will appear on the display panel, along with the current number and channel indication: "WB-1", "WB-2", "WB-3", "WB-4", "WB-5", "WB-6" or "WB-7". The seven frequencies are shown in the following table: Table 1: WB Frequencies NOAA Weather Alert The Weather Alert function adds an additional level of user safety by automatically switching from any of the available function modes to weather band for a minimum of 60 seconds if a NOAA warning tone (1050 Hz) is received/detected. If no additional warning tone is received for 60 seconds, the unit will switch back to the last known function mode. See "System Menu" on page 6 to learn how to turn the WB Alert feature on. SAME Decoding and Filtering Specific Area Message Encoding (SAME) data is also broadcast prior to alert broadcasts. SAME data contains information about the geographic region affected by the alert, the type of alert, and its effective time. The geographic region included in the SAME data is called the Geographical Area code and has the form PSSCCC where "P" represents a portion of the county, "SS" is a two-digit state, territory, or offshore marine area identifier and "CCC" identifies the county, province, or major metropolitan area within the state. This unit can be configured through the system setting menu with up to seven Geographical Area codes to limit the automatic tuning or power on functions described above. This unit can be configured through the System Setting Menu to limit the automatic tuning or power on functions based on the type of alert. SAME is activated by programming a 6 digit code - called a FIPS code - into your radio. The FIPS code or Federal Information Processing System code is a six digit code that identifies the states and counties (or parishes) in the United States. The next two digits identify the state or territory, and the last three identify the county. [. . . ] While the iPod is connected, the power cannot be turned on or off from the iPod itself. iPod iPhone iPod Press and hold the TUNE/SEEK |<< / >>| button (18, 19) to fast reverse/forward the song. NOTE: If you press and hold the TUNE/SEEK |<< / >>| button to change the current song to the previous/next song, you will exit fast reverse/forward mode. Playlist Search Press the PTY/CAT/MENU button (2) to access Playlist selection mode. While in Category mode, press the TUNE/SEEK |<< / >>| buttons (18, 19) to choose file search by Playlist, Artist, Album, Genre, Song, Audiobook or Podcast. [. . . ]