User manual JENSEN VOYAGER JHD1000

[. . . ] Replace the dashboard trim panel. M O UNTING TA B DE TA ILS C UT AW AY V IEW O F M OU NTING SU RF ACE TO P TA B B END S IDE V IE W U PW A R D 90 ° M O U NTIN G S URF ACE M OUNT IN G S LEEVE Installation (continued) Universal Installation (Using Mounting Sleeve) 1) Remove endcaps and slide the mounting sleeve off of the chassis. If it is locked into position, use the removal tools (supplied) to disengage it. 2) Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve slides easily into the opening. [. . . ] To exit, press AUDIO ADJUST again or the configuration menu time out (takes about five seconds). GRAY (-) GRAY/WHITE (+) GRAY (-) GRAY/BLUE (+) Configuration of Tuner Seek Sensitivity Setting 4 OR 8 OHM 4 OR 8 OHM The scan sensitivity feature is designed to give flexibility during the tuner seek function. The tuner can be configured such that during seek, it will stop on strong stations, ignoring weaker signals. The tuner can also be configured to stop at all weak signals. LEFT REAR SPEAKER RIGHT REAR SPEAKER GRAY (-) GRAY/RED (+) GRAY (-) GRAY/YELLOW (+) To configure the seek sensitivity setting, press AUDIO ADJUST for more than three seconds. While in the general configuration menu, press preset 4 and then preset 2. Press the up tuning button until "SC--**" appears in the display (where ** can equal 00-15). The numbers are set such that at the setting "SC-00", the unit is more sensitive to weaker signals. This means that the seek function will stop at most or all weak signals. At "SC-15", the seek function will stop only at the strong stations. Use the up tuning button to adjust the seek sensitivity of the tuner to a setting that will suit the application. To exit, press AUDIO ADJUST again or the configuration menu time out (takes about five seconds). . 4 OR 8 OHM 4 OR 8 OHM 3 JHD1000 6. Alarm Clock Function Setting the Alarm Clock To set the clock to display the current time, turn the vehicle ignition on and turn the radio off. Press T/F (6a) for more than one second, and the time will flash in the display. Press the down tuning button (6b) to adjust the hours or the up tuning button (6c) to adjust the minutes. "A" or "P" will appear on the display to indicate AM or PM. When no adjustment is made for five seconds, the time will be set and normal operation will resume. The Liquid Crystal Display (LCD) panel (2) displays the frequency, time and activated functions. 3. Mode Press MODE (3) to select a different mode of operation as indicated on the display panel. [. . . ] The most you will receive will be two or three, and that is rare. Note: Seek tuning is not available for weather band channels. Use the up or down tuning buttons to manually select any of the seven available weather band channels. Is it possible I won't receive any stations? Depending on where you are located, there is a possibility you will receive only a very weak signal or none at all. Also, similar to AM and FM signals, weatherband signals are subject to surrounding conditions, weather, obstructions of the signal by hills or mountains, etc. JHD1000 Radio Operation PUSH POWER AUDIO MODE ADJUST How will I know I am tuned to Weatherband? 10 2 4 6 3 5 T / F HEAVY DUTY AUX IN When you select the weather band, the indication "WTHR" will appear on the display panel, along with the current channel indication: "CH1", CH2", "CH3", "CH4", "CH5", "CH6" or "CH7". [. . . ]