User manual JENSEN VOYAGER CSW3007 INSTALLATION
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JENSEN VOYAGER CSW3007. We hope that this JENSEN VOYAGER CSW3007 user guide will be useful to you.
Manual abstract: user guide JENSEN VOYAGER CSW3007INSTALLATION
Detailed instructions for use are in the User's Guide.
[. . . ] [. . . ] Remove crank, spring, directional handle, & 4 screws.
TooLs & suppLies
1 · DrillorBatteryDriverwitha#2Philipsbit 2 · PuttyKnife 3 · 3/32"Allenwrench 4 · ElectricalTape 5 · ExteriorRoofSealant(Non-hardeningtype)
2
3
Remove sealant & screws from base, remove antenna and clean surface
4
Apply sealant to all holes & attach exterior plate using the included hardware
5
Apply sealant to holes and attach base using the included hardware.
8
install interior plate using included hardware over hole in ceiling.
AsA eLeCTRoNiCs CoRpoRATioN
8) Install interior plate using included hardware over hole in ceiling
8) Install interior plate using included hardware over hole in ceiling
www. jensenrvdirect. com www. asaelectronics. com
© 2010 AsA electronics Corporation
R in
Refer to the ANHD20 installation/operation for additional installation details.
6
Apply sealant to 3 screws, fill coax hole, connect coax to antenna and wrap connection with insulating electrical tape. Coax connection should be located inside vertical stalk of antenna for service.
9) Remove plate from wall and disconnect all wires and wires and power/ground cables (note 9 Remove plate from wall and disconnect all cables labels) polarity & cable(note power/ground polarity & cable labels).
9) Remove plate from wall and disconnect all wires and cables (note power/ground polarity & cable labels)
7
7) Attach antenna to base and seal all seams and screws on plate and antenna base 7) Attach antenna to base and seal all seams and screws on plate and antenna base
Attach antenna to base and seal all seams and screws on plate and antenna base.
10
10) Connect appropriate cables / wires and install new plate. Tape all coax connections.
8) Install interior plate using included hardware over hole in ceiling
Refer to the ANHD20 Installation / Operation for additional [. . . ] [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JENSEN VOYAGER CSW3007
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JENSEN VOYAGER CSW3007 will begin.