User manual JENSEN JTA-475

[. . . ] Although The JTA-475 Navigator can easily be discovered by experience, it is still recommended that you read through this manual to clearly understand the exact function of each button and icon. NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA: State law prohibits drivers in California and Minnesota from using suction mounts on their windshields while operating motor vehicles. Audiovox does not take any responsibility for any fines, penalties, or damages that may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes 2005, Section 169. 71) III Table of contents 1 2 3 Warnings and safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 General information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Pin: push a colored pin in the map at the selected point for later use. This pin is visible at all zoom levels and also appears in the History list together with its exact position. This menu point replaces Pin and is available only if the selected point is near or at a pin. · · · · · · 37 · Add POI: opens the new POI capture window to let you add the selected map point to the list of your user points. This menu point is only available on the Map screen and if there are no POIs near the cursor (i. e. If you want to add a new POI at the cursor, you can do so by tapping New in the bottom left corner. This menu point replaces Add POI and it is only available in the Map screen and if there is at least one POI item near the Cursor. · 4. 5. 14 Current street (No. 16) This field of the Cockpit screen shows the name or number (as available) of the current street or road you are driving on. You can hide these alternative names in Map settings (5. 2. 3). 4. 5. 15 Travel and Route data (No. 17) The contents of these three fields are different when cruising (without an active route) or navigating (following an active route). While cruising, the fields show the present speed, the current speed limit and the time of day. You can choose what to display in these three fields during navigation, by going to Advanced settings / Display Options (5. 6. 1). This is the distance you need to travel on the route before reaching your final destination. If via points exist, tap and tap again any of the fields to see the distance to reach the first, second, etc. It either displays the `Route' or the `Vehicle' field from the Route parameter settings. If you have chosen Car, Taxi, Bus or Lorry, the type of the route (Fastest, Shortest or Economical) will be displayed here; if you have selected Emergency, Bicycle or Pedestrian, this information will be displayed here. 4. 6. 1. 4 Time Left This is an estimated value that can also be displayed in one of the Route data fields on the Cockpit screen as `Time to destination'. It shows the time needed to reach the final destination of the route based on information available for the remaining 40 segments of the route. The calculation cannot take into account traffic jams and other possible delays. If via points exist, tap and tap again any of the fields to see the time needed to reach the first, second, etc. 4. 6. 1. 5 Estimated Arrival This is an estimated value that can also be displayed in one of the Route data fields on the Cockpit screen as `ETA to destination'. It shows the time needed to reach the final destination of the route based on information available for the remaining segments of the route. The calculation cannot take into account traffic jams and other possible delays. [. . . ] Use the / / button (the label depends on the current cursor position inside the latitude) to start entering minutes after degrees or seconds after minutes. When finished, tap the longitude on the right, and enter it as you did latitude. This tells The JTA-475 Navigator whether the time the hemisphere-changing button point is located East or West from the meridian crossing Greenwich, UK. 83 Once you have entered both numbers, press done to make the selection. Tip: The quickest way to tell the coordinates of a point is to select it by tapping on the map or by using Find, and then come to this page and read the coordinates. [. . . ]