User manual JENSEN CD-540

[. . . ] Make it a practice to remove the AC cord by grasping the main body and not by pulling the cord. The use of controls or adjustment or performance of procedures other than those specified here may result in exposure to hazardous radiation. · Place the unit on a flat and even surface. · Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it with a cloth or by placing it on a carpet. ON CONDENSATION · When left in a heated room where it is warm and damp, water droplets or condensation may ON PLACEMENT · Do not use the unit in places where are extremely hot, cold, dusty or humid. form inside the unit. · When there is condensation inside the unit, the unit may not function normally. [. . . ] When tuning in AM reception, be sure to place the unit in a vertical position. To insure best AM reception, try repositioning the unit until the best station reception is obtained. - EN 8 - CD PLAYER OPERATION Note: This CD player will not only play commercial CDs, but also self-compiled CD-R/RW discs. Notes on CD-R/RW Discs · Because of non-standardized format definition/production of CD-R/RW, playback quality & performance are not guaranteed. · Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as PC performance, writing software, media ability, etc. · Do not attach a label or seal to either side of the CD-R/RW disc. Carefully place an audio CD with its label side upward in the CD compartment and close the CD Door by pressing on the CD Door (# 11) where PUSH CLOSE is indicated. The LED Display (# 23) will briefly display flashing "- -"and then the total number of tracks on the CD will appear in the LED Display (# 23) after a few seconds. The Play/Program Indicator (# 25) will light and the CD will start playing from the first track. Adjust the Volume Control (# 1) to obtain the desired sound level from the Built-in Speakers. To suspend playing, press the CD PLAY/PAUSE Button (#12) and the track No. You can choose to play your favorite track directly by pressing either the Skip Forward Button (# 19) or Skip Backward Button (# 20). The LED Display (# 23) will indicate the correct track number selected. To locate a particular passage within a track, keep the CD Search Forward Button (# 19) or CD Search Backward Button (# 20) depressed until it is found. To repeat a particular track, press the CD REPEAT Button (#13) until the CD Repeat 1/All Indicator (# 24) flashes. To repeat the entire CD, press the CD Repeat Button (#13) until the CD Repeat 1/All Indicator (# 24) lights steadily. When you wish to turn off the CD Player, set the Function Selector (# 27) to the "TAPE" position. 2. CD PROGRAMMED PLAY This function allows the tracks to be played in a programmed sequence. Press the CD Skip Forward Button (# 19) or CD Skip Backward Button (# 20) to select the song to be programmed. 4. 5. 6. 7. 8. Press the PROGRAM Button (#9) again to store selection. [. . . ] Symptom Noise or sound distorted on AM or FM broadcast Possible Cause Station not tuned properly for AM or FM. AM: Internal antenna is not positioned correctly Unit not in Tuner mode, AM or FM band. It the CD is self-compiled, the media used may not be compatible with the player. Player is subject to excessive shock or vibration Unit not at TAPE function mode Volume at minimum Dirty tape head Tape old or worn Dirty roller and capstan Prevention tab removed Defective tape or dirty tape head Solution Fine tune the AM or FM broadcast station. [. . . ]