User manual JBSYSTEMS THE WINNER II V1.1

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBSYSTEMS THE WINNER II. We hope that this JBSYSTEMS THE WINNER II user guide will be useful to you.


JBSYSTEMS THE WINNER II V1.1: Download the complete user guide (2639 Ko)

Manual abstract: user guide JBSYSTEMS THE WINNER IIV1.1

Detailed instructions for use are in the User's Guide.

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. ⷠKeep this booklet in a safe place for future consultation. To protect the environment, please try to recycle the packing material as much as possible. ⷠA new light effect sometimes causes some unwanted smoke and/or smell. [. . . ] ⷠDue to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. DMX output: 3pin female XLR-connector used to connect the Winner (or Rover) with the next unit in the DMX chain or with another Winner (or Rover) when used in master/slave mode. Button used to control the music sensitivity In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Use a screwdriver to unscrew the screw that closes lamp compartment of the fixture. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands!If you touched the lamp, clean it with a cloth and a little denatured alcohol. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. This input receives instructions from a DMX-controller or from another Winner (or Rover) light effect when used in master/slave mode. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. ⷠMake sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. ⷠLocate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. ⷠThe device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. ⷠAlways use a certified safety cable that can hold 12times the weight of the device when installing the unit. [. . . ] During inspection the following points should be checked: · All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. ⷠHousings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. ⷠWhen an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. ⷠThe mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBSYSTEMS THE WINNER II




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBSYSTEMS THE WINNER II will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.