User manual JBSYSTEMS RF-8 SET V 1.0

[. . . ] This symbol means: indoor use only This symbol means: Read instructions To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] Three control buttons for optimal control of all kinds of different light effects: STANDBY: switch the output of each unit on/off MODE: different working modes can be selected (audio, auto, fast, slow, . Always in control of your light effects, even while they are used in master/slave setup: simply connect the RF-8R to the master. Maximum working distance: up to 100m Working frequency: 433, 92MHz Data connector: DIN 5pin *Check if your light effect is adapted for use with this wireless RF-8SET. Do not use volatile liquids such as benzene or thinner which will damage the unit. CONTROL BUTTONS: these 5 groups of 3 buttons make it possible to control 5 different light effects. STANDBY BUTTONS: used to switch the light output of the light effects on/off. FUNCTION BUTTONS: the available functions completely depend on the light effect you want to control. Please check the user manual of your light effect to see which functions are available. MODE BUTTONS: the different working modes completely depend on the light effect you want to control. Please check the user manual of your light effect to see which working modes are available. Check the contents: Check that the carton contains the following items: RF-8T wireless transmitter RF-8R RF-receiver User manual Some important instructions: Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. [. . . ] Choose which of the 5 button groups (2) on the RF-8T should control your light effect and press one of the 3 buttons of the group you selected. Cancel the current setup: If you want to cancel the current setting (for example you want to use another group of buttons to control your light effect), follow the steps below: A. Press the SETUP button (8) for about 5seconds until the RF-SIGNAL LED (9) is lit B. [. . . ]