User manual JBSYSTEMS MINI LOGO V1.1

[. . . ] Precise optics for sharp projections Switch for gobo rotation: fixed gobo or rotating gobo Adjustable focus Fan cooling with overheat protection Perfect for clubs, pubs, bars, shops, parties, homes, etc. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Don't use the effect in the presence of persons suffering from epilepsy. Hanging bracket with 1 knob to fasten the unit and a mounting hole (M8) to fix a mounting hook like CR16/30. Remove the cover of the lamp compartment and gently loosen the screw that fixes the gobo holder You can do this easily with a small pincer. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands!If you touched the lamp, clean it with a cloth and a little denatured alcohol. Make sure you can read the text on the gobo when you look from the reverse side otherwise your text will be mirrored. make sure that the end of the fixation ring locks in the groove of the gobo holder. Put the gobo holder back in place and tighten the screw firmly to keep the gobo holder in place. Put the cover of the lamp compartment back in place and tighten the screw. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. [. . . ]