User manual JBSYSTEMS ME 2 V1.2

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBSYSTEMS ME 2. We hope that this JBSYSTEMS ME 2 user guide will be useful to you.


JBSYSTEMS ME 2 V1.2: Download the complete user guide (1323 Ko)

You may also download the following manuals related to this product:

   JBSYSTEMS ME 2 (1324 ko)

Manual abstract: user guide JBSYSTEMS ME 2V1.2

Detailed instructions for use are in the User's Guide.

[. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. ⷠDon't place metal objects or spill liquid inside the unit. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. [. . . ] ⷠIn the event of serious operating problems, stop using the appliance and contact your dealer immediately. ⷠPlease use the original packing when the device is to be transported. ⷠDue to safety reasons it is prohibited to make unauthorized modifications to the unit. iNSTALLATION GUIDELINES: · Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. ⷠPlacing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. ⷠWhen installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. (example: JB Systems code: 2-0370) For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. With the channel faders you can change the input level of each connected audio source. The audio risks to be distorted when the signal level comes in the red zone of the VU-meter. You can also use the VU-meter to compare the signal level of the input channels with that of the master output. Equalizer controls: When the equalizer is switched on, you can use these 3 faders to change the audio to your personal taste. Echo level control: Used to control the level of the echo signal that will be mixed with the original. Use it to make the perfect balance between the original and the effect signal. Echo repeat control: Used to control the feedback or number of echoes you want to create. Together with the delay time (8) you will be able to create the echo you desire. Echo Delay time: With this control you can set the length of the delay time. Together with the repeat time (7) you will be able to create the echo you desire. [. . . ] Talkover switch: Use this switch to mute the music channels (2 to 5) while you are talking through the DJ microphone. Crossfader: With this fader you can mix over between channels 3 and 4. The crossfader only works when you move the faders (19) of both channels to the desired level! Attention: For each input you must set the corresponding input selector on the front panel in the correct position! [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBSYSTEMS ME 2




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBSYSTEMS ME 2 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.