User manual JBSYSTEMS LED WATER WAVE V 1.0

[. . . ] If a foreign object enters the unit, immediately disconnect the mains power. Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. Don't cover any ventilation openings as this may result in overheating. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] This device has been designed to produce decorative effect lighting and is used in light show systems. LED Water wave combines the latest LED technology and excellent optics to project very realistic water waves in ever changing colors. based on 10WATT "CREE" LED technology: Very low power consumption (money saving!) Extremely brilliant colors compared to units with halogen lamps No lamp replacements! virtually no heat production Lightweight (no lamp transformers needed) Completely silent , no noisy fans needed!Equipped with 2 special frost filters 6 slowly changing dichroic colors Switch to stop the color wheel on a desired color. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. [. . . ] The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Mains Input: Power consumption: Fuse: Sound Control: Beam angle: Lamp: Size: Weight: AC 230V, 50Hz 20W 250V~ 500mA slow blow (20mm glass) --34° 10Watt white CREE LED see drawing 3, 5kg Once connected to the mains the device starts running. Do not switch the unit on and off in short time intervals as this reduces the life of the unit. [. . . ]