User manual JBSYSTEMS IMOVE 7S V1.0

[. . . ] Easily controlled by our Scanmaster SM1216, iLEAD controller or any other DMX controller This symbol means: indoor use only. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] Press the fixation-ring together and insert it in the front of the gobo. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. LEDS DMX On DMX input present MASTER On Master mode SLAVE On Slave mode SOUND Flashing Sound activation BUTTONS MENU DOWN UP ENTER To select the programming functions To go backward in the selected functions To go forward in the selected functions To confirm the selected functions REMOTE CONTROL INPUT: Used to connect an optional CA-8 hand controller while the unit is used in standalone or master/slave mode. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. Show Mode Used to choose the Show mode when used in standalone or master/slave mode. Once the right mode shows on the display, press the ENTER button to save it. [. . . ] In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. [. . . ]