User manual JBSYSTEMS ICOLOR 4 MK2 V 1.2

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBSYSTEMS ICOLOR 4 MK2. We hope that this JBSYSTEMS ICOLOR 4 MK2 user guide will be useful to you.


JBSYSTEMS ICOLOR 4 MK2 V 1.2: Download the complete user guide (5602 Ko)

Manual abstract: user guide JBSYSTEMS ICOLOR 4 MK2V 1.2

Detailed instructions for use are in the User's Guide.

[. . . ] â· Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. â· Don't cover any ventilation openings as this may result in overheating. â· Prevent use in dusty environments and clean the unit regularly. â· Inexperienced persons should not operate this device. [. . . ] Don't use the effect in the presence of persons suffering from epilepsy. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Use a screwdriver to unscrew the screw that closes the lamp compartment of the fixture. Hold the lamp firmly while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. This input receives instructions from a DMX-controller or from another iCOLOR4 Mk2 light effect when used in master/slave mode. DMX output: 3pin female XLR-connector used to connect the iCOLOR4 Mk2 with the next unit in the DMX chain or with another iCOLOR4 Mk2 when used in master/slave mode. DIP switches, used to set the DMX-starting address and DMX-mode of the unit. In stand alone this red led blinks to the rhythm of the music, in DMX mode this led flashes when a DMX signal is detected. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. â· Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. â· Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. â· The device should be installed out of reach of people and outside areas where persons may walk by or be seated. â· Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. â· Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. â· The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] â· The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. â· In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. â· The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. â· The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBSYSTEMS ICOLOR 4 MK2




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBSYSTEMS ICOLOR 4 MK2 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.