User manual JAMO 3S

[. . . ] Insert two 1" al (c) as shown in and wall bracket cover (c) wall bracket into wall bracket cover and tighten through wall bracket into wall bracket cover and wall bolts (d) with the supplied allen wrench. Insert two ½" allen bolts (e) into each side of tighten with t bracket and supplied tighten towards curvedInsert two ½" allen bolts (e) into each side of w allen wrench. The bracket can be for horizontal orfor horizontal the vertical placement of t Thebracket can be mounted included) appropriate for placement of or speaker. [. . . ] A switch located next to the terminals al-lows for adjustments of the level of the speaker in 10W, 5W, 2. mounting of speaker Place the speaker inside the curved bracket as shown in fig. 2 and insert thumb screws (j) through each end of the curved bracket into the speaker. The curved bracket can be ad-justed in the wall bracket by loosening the two ½" allen bolts (e) and re-tighten them after adjustment. Remove the grill from the speaker before painting and cover the front baffle (l) of the speaker. Apply many thin coats instead of a few thick coats to avoid the paint running or clogging the grill holes. In case of request for service under warranty, please enclose your original receipt and make sure that the serial number on the product is readable. Important: Never send the product to be repaired without the prior agreement of your dealer. If the product is NOT UNDER WARRANTY, all costs including without limit costs of repair and freight must be paid for by the customer. The warranty is only valid on presentation of the original sales receipt or other valid proof of purchase, and provided that the serial number on the product is fully legible. Warranty repairs must be carried out by an authorised Jamo dealer, or an authorised service centre. no payment will be made for repairs performed by unauthorised persons. This warranty does not extend to products which have been repaired or otherwise altered by unauthorised persons, and any damage to the product caused by work by unauthorised persons is not covered by this warranty. This product will not be considered defective, either in materials or in manufacture, to the extent that faults are caused by adaptation to national, local, technical or safety related requirements in countries other than the specific country where the product was purchased. Jamo shall at its option during the relevant warranty period either repair or replace defective components. In no circumstances shall Jamo be liable in contract, tort (including negligence) or breach of statutory duty or otherwise for loss of profits, loss of revenue, loss of data, loss of business or loss of anticipated savings or for any consequential loss whatever. The warranty does not cover the following: a) Periodic inspection, maintenance and repair or replacement of parts resulting from normal wear and tear. b) Costs connected to delivery to the dealer , disassembly or re-installation of the product. [. . . ] Fixation du support Le support peut être fixé de manière à y placer une enceinte à l'horizontale ou à la verticale. Mount the bracket with four screws (not included) appropriate support permet l'enceinte si the surfaceà de faire passer les fils devis (g) fig. Front of the speaker is exposed to rain directly entering the bass re the ports (under the grill), the ports should be closed to avoid lling t speaker with water. [. . . ]