User manual INTERMATIC TN111C

[. . . ] Follow all applicable electrical codes and regulations. Read instruction sheet carefully before installing fixture. Retain instructions for future reference. WARNING: Electric shock hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. WARNING: Fire hazard USE MIN 60°C SUPPLY CONDUCTORS. Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc. ) might collect. [. . . ] Avoid locations where humans or animals might accidentally touch fixture. WARNING: Explosion hazard Never operate light without securing the lens door. When light is operating, the gas in the lamp inner arc tube is at high pressure. Never operate light if the fixture lens or outer glass envelope of the lamp is broken or missing. WARNING: Explosion hazard Wear safety glasses and gloves when handling lamp. Metal Halide outer envelope is pressurized and could explode if broken. WARNING: UV hazard (Metal Halide Lamps Only) The type of lamp used in this fixture can cause serious skin burn and eye inflammation from short wave ultraviolet radiation if outer envelope of the lamp is broken or punctured, and the arc tube continues to operate. Certain types of lamps that will automatically extinguish when the outer envelope is broken or punctured are commercially available. Lens Door MOUNTING & WIRING 1. Screw the threaded mounting arm of the fixture into 1/2" NPS mounting hole on mounting device. Reflector Screw Mounting Arm Bolt Locknut Screw Lampholder Figure 1 Install with Lamp vertical Figure 2 2. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires as follows: (See Figure 3 or Figure 4) a. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. 1. [. . . ] This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. 1. Remove old lamp and replace with new lamp of correct type and wattage. [. . . ]