User manual INTERMATIC DD175MV
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual INTERMATIC DD175MV. We hope that this INTERMATIC DD175MV user guide will be useful to you.
Manual abstract: user guide INTERMATIC DD175MV
Detailed instructions for use are in the User's Guide.
[. . . ] HID Dusk-To-Dawn - DD Series
INSTALLATION INSTRUCTIONS Lamp Types: Mercury Vapor 175 Watt Models: DD175MV IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES
ELECTRICAL REQUIREMENTS
Read instruction sheet carefully before installing fixture. Retain instructions for future reference.
A qualified electrician should complete all required wiring. This fixture will accept 120 volt AC and must be properly grounded for safety. [. . . ] Attach the two-piece mounting bracket to the extension arm by interlocking the halves and securing with the bolt and hex nut provided. Leave approximately one inch of the extension arm protruding from the bottom of the bracket. Place the mounting bracket and arm assembly on the desired mounting surface. Put the assembly aside and prepare the marked locations for attaching the mounting bracket and arm assembly.
Fixture Bulb Socket Extension arm
Reflector
Lens
Lag Bolts (4) Connection Plug (Not Provided) Conduit Connector (Not Provided)
Mounting Bracket
Clamp
Mounting screws for reflector
Figure 1
Conduit (Not Provided)
3. 4.
Mount the extension arm assembly using the hex head lag bolts provided or other suitable method. Connect the supply grounding wire to the green screw located on the one-piece fixture mounting arm clamping bracket.
120 V
LAMP
COM
Secure the fixture to the arm using the one-piece clamping bracket and bolts provided. Fasten the reflector and lens assembly to the fixture using the two screws and washers provided. Insert the photocontrol into the socket on top of the fixture by aligning the prongs and twist clockwise to lock. The arrow on top of control should be pointed away from the mounting surface. If it is not, remove the photocontrol and reposition the socket on the top of the fixture by loosening the screw in the center of the socket. When power if first applied, some controls will turn the light on and turn off in two or three minutes. The fixture will take approximately 5-7 minutes to achieve full illumination. To check operation during daylight, cover the photocontrol with black electrical tape. 2.
Do not use lamp beyond manufactures rated life to reduce chance of lamp rupture. Turn lamp off at least once for 15 minutes per week to reduce chance of lamp rupture.
3. Remove old lamp and replace with new lamp of correct type and wattage. [. . . ] This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-6757000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage.
THESE INSTRUCTIONS DO NOT COVER ALL VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR ALL SITUATIONS RELATED TO FIXTURE INSTALLATION, OPERATION OR MAINTENANCE. FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com
158HL12129 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE INTERMATIC DD175MV
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual INTERMATIC DD175MV will begin.