User manual INFINITY PRIMUS THEATER PACK

[. . . ] If you suspect damage from transit, report it immediately to your dealer and/or delivery service. Open the package and verify the following contents: Couch Left Surround Channel Right Surround Channel (1) Center Figure 1. In this overhead view of a typical installation, satellite speakers are used to reproduce sound for the front and surround channels. The center channel reproduces sound and dialogue. The powered subwoofer provides bass for effects and music. Optional Infinity Subwoofer Right Front Channel Center Channel Left Front Channel Right Surround Channel (4) Satellite Speakers Left Surround Channel (16) Rubber Feet ········ ········ Figure 2. This figure shows an alternative layout, which may be more suitable for some rooms. PRIMUS THEATER PACK Co uc h 3 PLACEMENT NOTE: The satellite speakers can be placed directly on a shelf, or mounted on a wall using the built-in keyhole mount or optional wall brackets. WALL-MOUNTING THE SATELLITES The Primus satellites are designed to mount directly to a wall. [. . . ] If you already own a subwoofer, consult the subwoofer's manual for proper installation and connection instructions. ­ + 1/4"-20 Threaded Insert (remove cover) Step 2. Fasten two 1-1/2, " #10 wood screws to the wall using the markings placed in Step 1 as your guide. Place the speaker on the wall by aligning the keyholes on the back of the speaker to the screwheads on the wall. Once positioned properly, the speaker should slide down slightly and become secure. Each Primus satellite also allows for the use of third-party wall brackets using the 1/4" threaded insert located beneath the -20 keyhole mount. Consult the wall-bracket manufacturer for selection of proper bracket. ker on the wall by aligning the keyhole on the back of the speaker to the screwhead on the wall. Once positioned properly, the speaker should slide down slightly and become secure. 4 PRIMUS THEATER PACK CENTER AND SATELLITE SPEAKER CONNECTIONS Turn Off All Power After placing the speakers, you are ready to connect your system. Use at least #16-gauge speaker wire with polarity coding. The side of the wire with a ridge or other coding is usually considered positive polarity (i. e. , +). Also, consult the owner's manuals that were included with your amplifier or receiver to confirm connection procedures. Center Channel Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on the speaker. Connect the ­ (black) terminals in the same way. Important! Do not reverse polarities (i. e. , + to ­ or ­ to +) when making connections. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment. Satellites Observe polarities when making speaker connections, as shown in Figure 4. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the ­ (black) terminals in the same way. Important! Do not reverse polarities (i. e. , + to ­ or ­ to +) when making connections. [. . . ] If a problem exists in one loudspeaker, reverse the connection wires to the left and right system. If the problem remains in the same speaker, then the fault is with the loudspeaker. If the problem appears in the opposite speaker, the cause is in another component or cable. [. . . ]