User manual INDESIT PR 642 /I(GR)

[. . . ] The following information are applicable only for the UK and Republic of Ireland. Repairs and After Sales For product help and advice, repairs, spare parts or accessories, we're here to help. Use the diameter of the cookware To choose the most appropriate burner to cook with. SAFETY DEVICE stops the gas flow if the flame is accidentally Before operating your new appliance please read this instruction booklet carefully. [. . . ] Before connecting to the power supply, make sure that: · The appliance is earthed and the plug is compliant with the law. The socket can withstand the maximum power of the appliance, which is The voltage is in the range between the values indicated on the data plate. if the socket is Incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Unscrew the nozzles using a 7 mm socket spanner, and replace them With nozzles for the new type of gas (see table 1 "Burner and nozzle characteristics"). Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Remove the knob and adjust the adjustment screw, which is positioned In or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is Alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. [. . . ] check to make sure that: · You pressed the knob all the way in. You keep the knob pressed in long enough to activate the safety device. The gas holes are not blocked in the area corresponding to the safety device. Clean them by hand with warm water and non-abrasive detergent, Removing any food residues and checking that none of the burner openings is clogged. [. . . ]