User manual INDESIT EWE 61252 W EU

[. . . ] Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Running a wash cycle, 8 Detergent dispenser drawer Preparing the laundry Fast daily cycles Special wash cycles Load balancing system This instruction manual should be kept in a safe GB place for future reference. if the washing machine Is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Make sure that the washing machine has not been damaged during the transportation process. [. . . ] WASH CYCLE knob: used to set the desired wash cycle (see "Table of wash cycles"). OPTION buttons with indicator light: used to select the available options. The indicator light corresponding to the selected option will remain lit. Button with indicator light KEYPAD LOCK Locks the control panel (except for the ON/OFF button) in Order to prevent both children from changing the washing- Machine settings while in operation and any involuntary Press it for at least 2 seconds to enable/disable it. SPIN button : press to reduce or completely exclude the spin cycle - the value is indicated on the display. TEMPERATURE button : press to decrease or completely exclude the temperature: the value will be shown on the display. DELAYED START button : press to set a delayed start time for the selected wash cycle. START/PAUSE button with indicator light: when the green indicator light flashes slowly, press the button to start a wash cycle. Once the cycle has begun the indicator light will remain lit in a fixed manner. To pause the wash cycle, press the button again; the indicator light will flash in an orange colour. If the symbol is not illuminated, the door may be opened (wait approximately 3 minutes). To start the wash cycle from the point at which it was interrupted, press the button again. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again. The display is useful when programming the machine and provides a great deal of information. The duration of the available programmes and the remaining time of a running cycle appear in section A; if the DELAY START option has been set, the countdown to the start of the selected programme will appear. Pressing the relative button, the machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recently-used settings if they are compatible with the selected cycle. The "programme phases" relative to the selected programme and the "programme phase" of the running programme appear The icons corresponding to "temperature" , "Programmed start" and "spin" If the symbol lights up, the display will visualise the set "temperature" value. If the symbol lights up, the display will visualise the set "spin" value. To prevent any damage, wait until the symbol turns off before opening the door. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened (wait approximately 3 minutes). To change a wash cycle while it is in progress, pause the washing machine using the START/PAUSE button (the START/PAUSE indicator light will flash slowly in an orange colour); then select the desired cycle and press the START/PAUSE button again. [. . . ] We recommend the use of special detergent which has been designed to wash delicate clothes. Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly greater than the washing rotation speed. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. [. . . ]