User manual HP M5035X

[. . . ] Use of a shielded interface cable is required to comply with the Class A limits of Part 15 of FCC rules. For more regulatory information, see the HP LaserJet 5035MFP electronic user guide. Hewlett-Packard shall not be liable for any direct, indirect, incidental, consequential, or other damage alleged in connection with the furnishing or use of this information. To position the device, select a sturdy, well-ventilated, dust-free area that is out of direct sunlight. [. . . ] Touch Manual Settings, and then enter the IP Address, Subnet Mask, and Default Gateway. For Macintosh software installation instructions, go to step 24 on page 9. 20) Install the software from the CD before connecting the cable to the device. Follow the onscreen instructions, accept the default selections, and then go to step 31 on page 10. Note: If the welcome screen does not appear, click Start, and then click Run. When prompted, connect a USB cable between the device and the computer. Important: Perform steps 26-30 only if the USB cable was connected before the software was installed. 26) From Apple System Preferences (available in the Apple drop-down menu) click Print & Fax, and then click the Printing tab at the top of the window. 27) To add your device, click the "+" icon to launch the Printer Browser. By default, the Printer Browser displays devices that are connected through USB, Bonjour, and AppleTalk networking. Note: If HP software is installed, the software should automatically be configured for Macintosh OS X V 10. 29) Click Add to create a printer queue, and then follow the prompt to manually configure the device's installable options. 3 might require you to manually select the printer model from the Printer Model drop-down menu. 30) Under Model Name, select the device, click Add, and go to step 31. 31) Print a page from any program to make sure that the software is correctly installed. 33) Type the device IP address (found on the Jetdirect configuration page). Note: If you are using an Internet Service Provider (ISP) for Internet access and e-mail you might need to contact your ISP to obtain the SMTP server name, and to determine if you need to enter an account name and password for SMTP authentication. 38) Select The E-mail Address Book from the left navigation area to enter frequently-used e-mail addresses and e-mail distribution lists. 39) To scan a document to your computer or shared network folder, use the Send To Folder feature (on the left navigation bar) to set up one or more folder destinations. Note: See the embedded Web server (EWS) guide for more information on configuring the Send To Folder feature. [. . . ] Digital sending tab in the embedded Web server (EWS) does not appear Select Log On in the upper right corner of the EWS. Email Gateway Not Responding appears on the control-panel display when attempting to send an e-mail Contact your IT administrator to obtain the correct address. 2) If you are using an Internet Service Provider (ISP) for e-mail, contact your ISP provider the hostname of your SMTP gateway (request the fully qualified domain name (FQDN), not the IP address). 3) Make sure that the entered SMTP authentication user name and password are correct. [. . . ]