User manual HITACHI ULTRASTAR 36XP QUICK INSTALLATION GUIDE

[. . . ] IBM storage products Quick installation guide Ultrastar 36XP Multi-mode SE/LVD Models: DRHS-36V DRHS-36D Handling precautions 1. Always handle the drive with care to prevent damage from shock, vibration, or electrostatic discharge (ESD). [. . . ] (This drains static electricity from the package and from your body. ) 7. Save your drive packaging materials including the ESD bag in the event that the drive must be returned. Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. 24 6 8 10 12 14 16 18 20 22 24 26 28 30 32 Ground Reserved +5V Ground Termination Power Enable Ground Note: In the table below, "off" means a jumper is not in place and "on" means a jumper is in place. Bit 3 off off off off off off off off on on on on on on on on Bit 2 off off off off on on on on off off off off on on on on Bit 1 off off on on off off on on off off on on off off on on Bit 0 off on off on off on off on off on off on off on off on Address 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Installation procedure It is advisable to back up all data before proceeding with the installation. Page 1 IBM Hard Disk Drive Technical Support Center version 2. 0 IBM storage products 2. To format the primary system drive, type FORMAT C:/S at the DOS command prompt and press [ENTER]. To format a second drive (not C:), type FORMAT X: (where X is the drive letter assigned by FDISK) at the DOS prompt and press [ENTER]. If your system will not boot up after complete installation, recheck all settings. If the system still fails to boot up, remove the new drive to return the system to its original configuration and call the IBM Hard Disk Drive Technical Support Center. 68 Pin Auxiliary Connector :::::: SCSI Address ID2 +5V 11 9 ID3 7 ID0 ID1 531 12 10 8 Write Protect Ground 642 Unused Reserved External Activity LED Auto Spin Start ® © International Business Machines Corporation 1999 www. ibm. com/harddrive IBM Hard Disk Drive Technical Support Center Dept. D8M 3605 Highway 52 North Rochester, MN 55901 Telephone: 888. IBM. 5214 or 507. 286. 5825 Fax: 507. 253. DRIVE E-mail: drive@us. ibm. com Singapore Technical Support Center Telephone: 1800. 418. 9595 or 65. 6. 418. 9595 E-mail: drive@sg. ibm. com IBM Systems Storage Division 5600 Cottle Road San Jose, CA 95193 www. ibm. com/storage Asia-Pacific Headquarters: 65. 320. 1234 European Headquarters: 44. 01. 705. 561. 871 Japan Sales Branch Office: 81. 46645. 1039 Printed in the United States of America 01-99 All Rights Reserved IBM is the registered trademark of International Business Machines Corporation. Other company, product, and service names may be trademarks or service marks of others. OEM Hardware/Functional Specification, version 1. 02 Parallel SCSI Disk Drive Logical Interface Specification, release 1. 2 Product Description data represents IBM's design objectives and is provided for comparative purposes; actual results may vary based on a variety of factors. Questions regarding IBM's warranty terms or methodology used to derive this data should be referred to the IBM Hard Disk Drive Technical Support Center. If the DRHS drive is the only device on the SCSI cable, attach it to the end of the cable furthest from the controller. (Note that the using system is responsible for making sure that all required signals are terminated at both ends of the cable. ) 3. [. . . ] Partitioning and formatting (using DOS 5. 0 or later) Caution: Be sure that you select the correct hard drive. At the DOS prompt type FDISK, press [ENTER], and follow the instructions on the screen. Page 2 IBM Hard Disk Drive Technical Support Center version 2. 0 [. . . ]