User manual HITACHI HDC-1051E

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If the access speed of your SD memory card is not enough for recording video clips in the ] will appear, and then the movie recording will stop. currently selected quality, a warning icon [ In this case, select a video quality lower than the current one. EN-45 [ ] Panorama Mode This mode is designed to make it easier to take a series of shots then stitch them together with software to make a single photo. You can capture a photographic subject that won't fit into a single frame, such as a landscape, and stitch it together later with a program such as Cool 360 or Photoshop application. Orient the camera so that the second frame overlaps a small portion of the photographic subject of the first image and press the shutter button to capture the next image. Finish the sequence by pressing the SET button after the last image has been recorded. [ ] Anti-Shake Mode The anti-shake function works according to the luminance of the target object. This function uses special image data processing for getting high sensitivity of CCD. High sensitivity can use higher shutter speed compared with normal mode, so it reduces influence of hand shaking. Compose the image, press the shutter button down halfway, then press it down fully. EN-46 Recording a Subject onto an Existing Background Image (PreShot) Pre-Shot helps you get the background you want, even if you need to ask someone else to record the image for you. You compose the background you want and press the shutter button, which causes a semi-transparent image of the background to remain on the monitor screen. Ask someone else to record a shot of you against your original background, telling him/her to compose the image by using the semi-transparent monitor screen image as a guide. Depending on how the image is actually composed in step 2, its background may not be exactly the same as the one you composed in step 1. Record the image, using the background on the monitor screen as a guide. Slide the mode switch to [ ] and set the mode dial to one of the photography modes, except for [ ], [ ] and [ ]. Compose the background you want on the monitor screen, and then press the shutter button to temporarily record it as a reference image. This operation causes a semi-transparent image of the background to appear on the monitor screen, but the displayed image is not actually saved in camera memory. Now you can stand in front of the background and ask someone else to snap your picture, using the semi-transparent background on the monitor screen as a composition guide. After composing the final image (using the semi-transparent background as a guide), the person with the camera should press the shutter button to record. Note that the semi-transparent background image you temporarily record in step 2 is for composition purposes only. The final image contains only what is in front of the camera when the shutter button is pressed in step 4. EN-48 Combining Shots of Two People into a Single Image (Coupling Shot) The Coupling Shot mode lets you record images of two people and combine them into a single image. This makes it possible for you to include yourself in group images, even when there is no one else around to record the image for you. Combined Images First Image Second Image This is the part of the image that does not include the person who is recording the first image. 1. Align the focus frame on the screen with the subject you want on the left side of the image. [. . . ] Allows you to connect an AC power adapter to operate the camera without battery, or to charge rechargeable lithium-ion battery. 6x optical zoom lens allows you to capture telephoto and wide-angle images. Description Provides menu information to operate The camera, previews the image before capturing LCD monitor it and review it afterwards. Magnifier Allows you to enlarge your image on the selected portion of the image to check for small details. [. . . ]