User manual HITACHI CP-X4014WN

[. . . ] Projector CP-X2514WN/CP-X3014WN/ CP-X4014WN/CP-WX3014WN User's Manual (detailed) Operating Guide Thank you for purchasing this projector. WARNING Before using this product, please read all manuals for this product. After reading them, store them in a safe place for future reference. About this manual Various symbols are used in this manual. WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] Loosen the screw (marked by arrow) of the lamp cover and then slide and lift the lamp cover to the side to remove it. Loosen the 3 screws (marked by arrow) of the lamp, and slowly pick up the lamp by the handles. 4 Handles Insert the new lamp, and retighten firmly the 3 screws of the lamp that are loosened in the previous process to lock it in place. While putting the interlocking parts of the lamp cover and the projector together, slide the lamp cover back in place. Turn the projector on and reset the lamp time using 6 the LAMP TIME item in the OPTION menu. (2) Point at the ADVANCED MENU in the menu using the / button, then press the button. (3) Point at the OPTION in the left column of the menu using the /button, then press the button. (4) Point at the LAMP TIME using the / button, then press the button. 7. NOTE · Please reset the lamp time only when you have replaced the lamp, for a suitable indication about the lamp. 94 Maintenance Replacing the lamp (continued) Lamp warning HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE WARNING The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition, if the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury and dust containing fine particles of glass to escape from the projector's vent holes. About disposal of a lamp: This product contains a mercury lamp; do not put it in a trash. · For product disposal, consult your local government agency or www. eiae. org (in the US) or www. epsc. ca (in Canada). · If the lamp should break (it will make a loud bang when it does), unplug the power cord from the outlet, and make sure to request a replacement lamp from your local dealer. Note that shards of glass could damage the projector's internals, or cause injury during handling, so please do not try to clean the projector or replace the lamp yourself. · If the lamp should break (it will make a loud bang when it does), ventilate the room well, and make sure not to inhale the gas or fine particles that come out from the projector's vent holes, and not to get them into your eyes or mouth. · Before replacing the lamp, turn the projector off and unplug the power cord, then wait at least 45 minutes for the lamp to cool sufficiently. Handling the lamp while hot can cause burns, as well as damaging the lamp. · Never unscrew except the appointed (marked by an arrow) screws. · Do not open the lamp cover while the projector is suspended from a ceiling. This is dangerous, since if the lamp's bulb has broken, the shards will fall out when the cover is opened. [. . . ] MERK · Informasjonen i denne håndboken kan endres uten varsel. · Produsenten påtar seg intet ansvar for eventuelle feil som fremkommer i denne håndboken. · Reproduksjon, overføring eller bruk av dette dokumentet eller deler av det, er ikke tillatt uten uttrykt skriftlig tillatelse. OPMERKING · De informatie in deze handleiding kan zonder voorafgaande kennisgeving veranderd worden. [. . . ]