User manual HASE LUNO GAS

[. . . ] 7 Carport box auto o fabbricati annessi 46 Se un tubo di scarico sbocca in un carport box auto o un fabbricato annesso, deve essere Dear Hase Customer With your Hase Gas you have chosen a quality product. Handicraft tradition, an elegant design and the latest technology guarantee you years of joy and reliable service. The body of the Gas fire consists of strong steel plates that have been produced using modern welding engineering. Heat-resisting stones in the fire chamber and heat-consistent special varnish guarantee stability and a long service life of all Hase models. [. . . ] Balanced Flue appliances can be installed into a house without the need for additional ventilation. 6 room that has a forced mechanical ventilation and/or fume extraction without any special extra requirements. The European CE approval on this appliance is restricted to the Flue systems as specified by the supplier, thus the appliance must only be installed with the original flue system, no others may be used. Timber Frame Construction Whilst it is possible to install room-sealed appliances in timber frame properties, great care needs to be taken to ensure that the flue assembly does not interfere with the weather proofing qualities of any outer wall which it may penetrate. Before attempting this work, further details need to be referenced, (e. Carport or Building Extension Where a flue terminal is sited within a carport or building extension, it should have at least two completely open and unobstructed sides. The distance between the lowest part of the roof and the top of the terminal should be at least 60 cm. Basements, Lightwells and Retaining walls Flue terminals should not be sited within the confines of a basement area, light well or external space formed by a retaining wall, unless steps are taken to ensure the products of combustion can disperse safely at all times. It may be possible to install this Balanced Flue system in such a location provided that it is not sited lower than 1m from the top level of that area to allow combustion products to disperse safely. Please make absolutely sure that all pipings are installed and fitted in compliance with the applicable national regulations. A minimum pipe size of 15mm should be used for the gas supply to within 1 metre of the appliance. 8mm pipe may only be used for the final connection to the stove, or within 1 meter of the appliance. an 8 mm nut and olive is supplied with the stove for the final pipe joint. A gas supply tap must be installed in the supply pipe work in a location that is easily accessible, such that the appliance may be isolated if necessary. Do not make any connections to the appliance until all supply pipes have been purged to expel any dust or debris. Failure to do this may result in a blocked injector or tap and will invalidate the guarantee Although a gas soundness test is made on all appliances before they leave the factory, the appliance should be tested for soundness before operating the stove. Place the remaining two intermediate logs so that the rear end is lying on top of the rear log and is touching the rear of the firebox. The opposite end of the logs should be sitting on the centre of the burner. Lay the final small log at the very front of the fire box, positioned so that it is in front of the Pilot shield (Fig. 16 Scatter the contents of the bag of embers on top of the burner and grate, these should be evenly spread, ensuring that the pilot is not impinged, and that no embers enter the Pilot Shield (Fig. 17 Place the four intermediate logs, so that rear of each is sitting on top of the large log and the opposite end of each log is lying towards the front of the fire. Lay the final small log at the very front of the fire box, positioned so that it is in front of the Pilot shield (Fig. [. . . ] It is very important to read these instructions thoroughly before lighting. This appliance will produce an odour and/or smoke for the first few hours of use when new. There is a monitoring system fitted to this appliance, which cuts off the gas supply upon the detection of a blocked flue. If this system activates and the appliance cuts out, allow 3 minutes before retrying the ignition, noting that the control tap must first be returned to the off position. [. . . ]