User manual HASE LIMA

[. . . ] This section contains important information on using this technical documentation. Nevertheless, suggestions for improvement and comments regarding any errors are always welcome. Non-compliance with this warning can cause severe injuries, or even death. [. . . ] Turn the stove until it reaches the next locking point and insert the stop bracket (C) into the designated opening. Use the same procedure to set the range of rotation for the left side. Always comply with the safety distances to combustible and flammable materials!If a floor plate is required, its size must match the rotating range of the stove. During shipment, condensation moisture can accumulate in the stove's interior, which may possibly lead to the appearance of condensation or water on the stove or flue pipes. Make sure the room is well-ventilated and open the windows and outside doors. If the maximum temperature is not reached during the first heating operation, you may notice an odour for a short period of time the next time the stove is used as well. Open fire grate Pile up any remaining ash and unburned Charcoal into the centre of the combustion chamber. Pull secondary air slider all the way out Pull out fire grate slider The surface of your stove was treated in a sandblasting machine before applying the colour coating. Despite careful and thorough inspection, there may still be some residual material in the stove body, which can fall out when your stove is being installed. To prevent any damage, please immediately vacuum up these small steel pellets with a vacuum cleaner. The first time a stove is operated, the heat development causes the emission of volatile components from the coating, sealing strips and lubricants, and smoke and odours can occur. At a higher combustion temperature, this one-time process can take between 4 to 5 hours. To achieve this higher combustion temperature, please increase the fuel quantity recommended in Section 8, , , Adding Fuel/ Heating with Nominal Thermal Output", by approximately 25%. To prevent adverse effects on health, nobody should stay in the room(s) during this process The firing up phase should be as short as possible, since higher emissions can occur during this phase. The slider settings described in Table 1 (see figure on the right) are recommendations that were determined under conformance testing conditions, in compliance with the relevant standard. Depending on the weather conditions and the draught capability of your chimney, accordingly adjust the slider positions for your Lima to the local conditions. The Lima may only be operated when the fire box door is closed; the fire box door may only be opened to add fuel. [. . . ] Close fire box door Wood should be used for the warming-up phase and when adding fuel for the first time, see "Warming-up Phase". As soon as a basic glowing firebed is reached, place 2-3 brown coal briquettes on the grate in the middle of the firebox, keeping a finger's width between the briquettes, and use the following procedure and settings: Heating with Brown Coal Briquettes Procedure 15 a B-VG (Austria), can only be operated when the fire box is closed; more than one device can be connected to the chimney. (A): FSPS-Wa-1614-A The following data applies to the chimney characteristics in accordance with EN 13384-1 / 2 Depending on the insulation of the building, the nominal thermal output of 6 kW indicated on 20 - 80 m² (subject to change) Dimensions: Stove Fire box Height 120, 5 cm 43 cm Width 48 cm 28 cm Depth 48 cm 30 cm 195/230 kg 1106 cm² 15 cm 10 cm The original Declaration of Conformity and associated documents are available from the manufacturer upon request. [. . . ]