User manual GAGGIA MAGENTA PLUS

[. . . ] Thanks to the intuitive interface, you can choose among 5 beverages and customise them according to your preferences. Before being packed, each of our high-quality machines undergoes rigorous testing in our laboratories in order to ensure its correct operation. Some coffee residue might be found in your machine, since real coffee is normally used during testing. In this user manual you will find all the information you need to install, use, clean and descale your machine. [. . . ] This machine allows you to change the settings of a beverage according to your preferences and save them (MEMO), by overwriting the previous settings. 3 All the settings that can be adjusted and/or selected are displayed on the screen. Based on the type of beverage, you can adjust and/or select: -- aroma intensity (only when using coffee beans); Press " " to confirm and return to the previous screen, where the new " button repeatedly to adjust the temperature of the 6 Press " " button to brew two cups, or " " for a single cup. The picture of the beverage in the centre of the display will indicate the number of cups selected. Note: this function is not available for beverages with milk, AMERICANO and HOT WATER. 8 To change the intensity of the aroma or select the pre-ground, press the " " button. Every time you press the " " button, the aroma strength changes by one degree. The display shows the selected intensity or the selection of the pre-ground. Note: the function Pre-ground allows the brewing of just one coffee at a time. 9 Once the beverage has been customised according to your preferences, you can proceed with dispensing it by pressing START/STOP button. Clean the brew group with the Gaggia coffee oil remover to remove any oily coffee residue When the red mark appears from Empty the drip tray and clean it under running Empty the coffee pucks container and clean it under running water. Ensure that the machine is switched on during this procedure, otherwise the coffee pucks container will not reset. When to clean Depending on usage How to clean Remove the espresso tray and clean it with running water. 1 Remove the classic pannarello and the rubber handle from the steam tube and rinse them under running water. To clean it more thoroughly, you can unscrew the nozzle and wash it with running water. Allowing the steam to escape for one or two seconds to clean the nozzle hole. Cleaning the brew group Warning: do not wash the brew group in the dishwasher and do not use dishwashing detergents, since they may cause the malfunctioning of the brew group and alter the coffee flavour. Removing the brew group 1 Turn off the machine and disconnect the power cord. 4 Press the PUSH lever (1) and pull the handle of the brew group (2) to remove it Cleaning the brew group under running water 1 Clean the coffee outlet duct thoroughly with a spoon handle or with another round-tipped kitchen utensil. 2 Rinse the brew group and the coffee residues drawer thoroughly with lukewarm water. Note: to avoid the build-up of fibres in its interior, do not dry the brew group with cloth. Reinserting the brew group 1 Before placing the brew group back into the machine, make sure that the two yellow reference marks on the side match. [. . . ] The machine requests to empty the coffee pucks container even if it is not full. The machine has not reset the counter last time the coffee pucks container has been emptied. Always wait about 5 seconds when you replace the coffee pucks container. If you empty the coffee pucks container when the machine is off, the coffee cycle counter does not reset. [. . . ]