User manual FERMAX BLUETOOTH STAND-ALONE ACCESS CONTROL V02.08

[. . . ] Your inseparable telephone, if it incorporates Bluetooth© technology, will let you open the doors. All you need to do is install a Bluetooth access control receiver and connect it to the electric lock or motor of the garage door, in parallel with the current door release system. The receiver can also be used as a panoramic card slot to lodge a card with the name of the building, stree number, . All you need to do is replace the card that the receiver has by default. [. . . ] Operating Mode Configuration All bluetooth receptors can be configured from a mobile phone with bluetooth connectivity. To configure the receiver, it is necessary to temporarily modify the bluetooth name of the telephone designated as administrator. This can be done with the corresponding bluetooth configuration option of the telephone. The telephone designated as administrator does not need to be on the list of authorised telephones. Modify the bluetooth name of the telephone that is to act as administrator by the code, in capital letters, corresponding to the function to be carried out (authorise users, delete. The table on the next page shows the list of codes and the action associated with each of them. Place the telephone that is to be administrator and the telephones to be added to the list, if any, close to the receiver. After approximately 20 seconds, the telephone acting as administrator will be asked for the Administrator PIN, NOT the User PIN. Once the administrator PIN has been introduced, the receiver will open the door twice, indicating that the maintenance order has been carried out. If the PIN is not entered correctly, the administration order will not be carried out. From this moment, the system returns to normal operating mode, and any PIN requested will always refer to the normal PIN used to open the door. Change the name of the bluetooth telephone for another different one of the administrator codes. 3 receptors or subsequent versions can also be configured from a PC or PDA with bluetooth connectivity and the corresponding programming software. The programming software can be downloaded from the Fermax webpage: www. System «Default» Configuration The factory configuration of the system is: - Operating mode WITHOUT authorised phones list with PIN request - User PIN: 1234 - Administrator PIN: 4444 - Door open timing: 3 sec. sets the receiver in stand-alone learning mode , automatically adding any telephones nearby at that moment to the list. They are added after those already in the list, without exceeding the maximum limit of 40. At every stand-alone learning session, a maximum of 4 new telephones can be added. So, if you need to add another one, you will have to do it in blocks of 4. It is important that there are no more than 4 in the coverage radius, because otherwise we shall not know which ones have been added. [. . . ] A) In PIN code request mode (with or without list of authorised telephones) or with Confirmation: The receiver detects the nearby telephones and alternates the PIN request among the telephones detected, with a 20 second interval, in order to avoid asking the same telephone twice in a row. B) Automatic Mode (with list of authorised telephones without PIN): The receiver detects the telephones nearby, and if there is more than one authorised telephone will open the door with an interval of 6 seconds. Why does my mobile take longer than normal to be detected by the Bluetooth receiver?Telephones with older versions of Bluetooth take longer to detect than telephones with the latest versions. [. . . ]