User manual FELLOWES CC4-2

[. . . ] See "MAINTENANCE. " ¥ Do not use this product if it or the cord has been damaged in any way. Doing so can expose you to dangerous voltages and will void your warranty. A. Shredder head ASSEMBLY NOTE: This shredder will operate only when used with the supplied basket. The supplied basket has a built-in safety feature which prevents the shredder from operating if used with any other basket or if improperly assembled. To assemble shredder: This shredder contains sharp edges on the underside of the shredder head. [. . . ] Slide paper straight into paper entry until the shredder automatically begins shredding. The shredder automatically stops a few seconds after shredding is complete. Continue shredding as desired to a MAXIMUM shredding time of 5-7 minutes. At this time, the machine MUST be allowed to "cool down" for a MINIMUM of 15 minutes. (See "Cool-Down Cycle" for more information. ) If the shredder jams or shuts off before the maximum shredding time, see "Clearing a Jam" section for further instructions. Unplug power cord from outlet whenever shredder is unattended or not in use. Replace shredder head onto basket. Cool-Down Cycle This shredder is protected with a special safety feature which prevents the motor from overheating with extensive use. When shredding is attempted beyond the machine's maximum running time, the shredder will automatically shut off its motor until it has cooled to an acceptable operating level. This is normal and the shredder will return to operation after the cool-down or "off" period. See "Product Usage Guide" on front panel for maximum running time and related cooling "off" time. Clearing a Jam If the shredder sheet capacity is exceeded or paper is not put in straight, a jam may result. See "Product Usage Guide" on front panel for maximum sheet capacity for your shredder. (NOTE: If waste basket is full, empty it before clearing jam. ) The shredder will reverse the paper to clear the jam. If the shredder jams in reverse, move the power switch to AUTO (I) and allow to run for about five seconds. If jam does not clear, move power switch to REVERSE (R) again and allow to run for about five seconds. If necessary, use care to grasp the paper carefully and pull out to clear the jam. Once the jam is cleared, move the power switch to AUTO (I) for continued shredding or OFF (O) if shredding is complete. MAINTENANCE Confetti cut shredders require regular (monthly) oiling of the cutting blades to maintain proper operation. Failure to oil the blades regularly could result in reduced sheet capacity performance, excessive noise during operation, paper jams and possibly shredder failure. We recommend using only Powershred Lubricant #35250 (available by contacting Fellowes) or a vegetable-based oil (such as corn or canola) in a nonaerosol container with an extension nozzle. Never use flammable synthetic oil, petroleum- based, or aerosol lubricants to oil the cutting blades. Some agents may combust, causing serious injury. To oil the cutting blades: 1. From the top of the shredder, squeeze the recommended lubricant across the full width of the blades. Move the power switch to AUTO (I) position and allow the blades to run at least 3 seconds. Move the power switch to REVERSE (R) position and allow it to run for at least 3 seconds. [. . . ] ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. For more detail or to obtain service under this warranty, please contact Fellowes Customer Service at 1-800-955-0959, Monday through Friday, 8 AM - 5 PM (Central Standard Time). For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact the appropriate location listed in the Contact for Service section of this instruction manual. [. . . ]