User manual EUREKA C65

[. . . ] For prompt and complete service information, always refer to these numbers when inquiring about service. _____________________________________ www. eureka. com IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: · Do not use outdoors or on wet surfaces. Turn off the switch and unplug the electrical cord when not in use and before servicing. · Do not allow to be used as a toy. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using. · Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. [. . . ] NOTE: See pages 13 & 14 for complete bag installation instructions. 10. 6 HOW TO USE 1. Turn to select hose for above floor cleaning or floor for floor surface cleaning. If cleaning hard floor surface also adjust the cleaner height setting to hard floor. The dirt alert sensor uses infrared technology to indicate whether or not floors are clean. When debris breaks the light beam, the red light comes on indicating additional cleaning is needed in this area. If there is no break in the light beam, the floor is clean and no light will come on. When using your new vacuum you may be cleaning deep down dirt missed by your old vacuum causing the light to stay red longer. With frequent cleaning, after the first few times you use your Eureka vacuum, the red light should go on less. While the red light is on, tip the vacuum backwards on rear wheels, lifting the brush roll off the carpet a couple of inches. Some models feature a bag change indicator to remind you to change the bag. When it is time to change the bag, the bag change indicator will illuminate. Make sure the latch (D) is open so the clear tube can be fully installed. Slide ribs at the bottom of the large clear tube (L) into the slot on the cleaner until the clear tube is vertical. Adjust small clear tube until quarter turn lock (O) is correctly located on back of cleaner. Close latch (R), securing the clear tubes at the top. J K R M O N P L 11 HOW TO MAINTAIN The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt, and brush roll often. Brush Roll The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll. Brush Roll Belt The brush roll belt turns the brush roll to agitate, sweep, and comb the carpet nap. Cut away any hair or threads wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly. How To Replace Brush Roll Belt, Part No. 61110 NOTE: Turn off the switch and unplug the electrical cord before replacing belt. [. . . ] Noise from the brush roll area. Light Bulb Brush Roll Belt Cleaner Height Setting Belt Brush Roll On/Off Belt Brush Roll On/Off New carpet fibers. Dirt sensor is not working. Cleaner is hard to push. Brush roll will not turn. Dirt Alert red light will not go off. Dirt Alert red light will not come on. Cleaning height knob will not turn. Bag cover will not shut or close. Cleaner Height Setting No paper bag. 16 THE EUREKA LIMITED WARRANTY What This Warranty Covers Your Eureka cleaner is warranted to be free from all defects in material and workmanship in normal household use for a period of one year. [. . . ]