User manual EUREKA 6989A

[. . . ] To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). If it still does not fit, contact a qualified electrician to install the proper outlet. Avoid picking up hard or sharp objects with the cleaner to prevent hose clogs with subsequent motor damage. For additional service information telephone our toll free number for the nearest Eureka Authorized Warranty Station. [. . . ] After the 30 minute period, plug the cleaner back in and turn on the switch. If the cleaner still does not run, then take it to a Eureka Authorized Service Center for repair. CAUTION: Do not plug in cleaner until you understand all controls and features. A) Mango de la manguera B) (x2) Tubos de Extensión C) Pedal de liberación rápida D) Motor de succión E) Pedal de liberación del mango F) Cepillo para polvo G) Presilla H) Boquilla para rincones I) Cepillo turbo (no se fija a la aspiradora) J) Cepillo para pisos sin alfombra K) Perilla de control de succión L) Interruptor para enrollar el cable M) Conexión de entrada para la manguera N) Mango O) Cubierta del filtro de escape P) Filtro del Motor WHIRLWIND 610 Q) Seguro del cobertor de la tapa de polvo R) Tapa para polvo S) Asa de la bolsa de polvo T) Seguro de la tapa de la bolsa de polvo U) Filtro del recipiente de polvo AIR EXTREME 600 Q) Seguro del cobertor de la bolsa de polvo V) Cesta de aire W) Bolsa desechable para polvo X) Indicador de cambio de bolsa de polvo Y) Filtro de escape Z) Accesorio para fijar el cepillo de piso AA) Cable de poder Step 1: Snap interlocking wands together (B) until the click sound is heard. Step : Place tool clip (G) over top of interlocking wand until the the clip is aligned with the raised edges on the wand. Step : Place hose handle into wands until plug connects and button locks (A). Step 6: Pull power supply cord (Y) out from back of cleaner and plug into electrical outlet. To rewind, remove from electrical outlet, step on cord reel button, hold and guide plug while it rewinds (L). Note: A carpet should be cleaned regularly over heavily traveled areas, and once a week over the entire carpeted area. Vacuum slowly, making several passes (forward and backward) over the carpet. The time required to clean the carpet will depend on several factors ­ including type of carpet and amount of dirt. 1) Step : Lift out the s-bag® from the Air Basket by pulling the card-board (Fig. Insert a new s-bag® by pushing the cardboard right into the end of the groove in the dust bag holderand close the lid. Should be done with every third replacement of the dust bag, s-bag®. Step 1: Open the front lid and lift out the Air Basket holdingthe s-bag®. Step : Pull the filter holder upwards until coming away from the groove (Fig. Step : Carefully pull the old, dirty filter out and replace with a new filter. Reattach the Air Basket holding the s-bag® and then close the lid. CAUTION: Turn off the switch and unplug the electrical cord before servicing. Hint: If picking up fine dust, the dust cup/bag may not look full, but a fine substance tends to reduce suction when it blocks airflow through the foam filter. For bare floor cleaning, make sure switch control is in bare floor position. Hint: If picking up fine dust, the dust cup/bag may not look full, but a fine substance tends to reduce suction when it blocks airflow through the foam filter. [. . . ] Defects or damages caused by unauthorized service or the use of other than Genuine Eureka parts. What Eureka Will Do Eureka will, at its option, repair or replace a defective cleaner or cleaner part that is covered by this warranty. As a matter of warranty policy, Eureka will not refund the consumer's purchase price. Warranty Registration Please fill out and return the warranty registration card accompanying your cleaner. [. . . ]