User manual EPSON STYLUS PHOTO RX690

[. . . ] Note: Remove the protective material under the cartridge cover before installing ink cartridges. If the Setup utility does not start, press the P power button on the printer and follow the instructions in the Macintosh section of this sheet, beginning from " 3. Install the ink cartridges. " When ink cartridge installation is complete, proceed to "Load paper and check the print head nozzles" on this sheet. Load paper and check the print head nozzles Make sure that the computer is turned on. [. . . ] Load paper into the sheet feeder making sure that the side of the paper that you wish to print onto is facing up and that the right edge of the paper is against the right edge guide. Next, slide the left edge guide so that it is against the left edge of the paper. left edge guide printable side up 2. Select the printer After you have installed the printer software, you need to select your printer. Then, select the icon for your printer and the port that your printer is connected to. Without applying excessive force, push the ink cartridges down until they click into place. To place them vertically, install the ink cartridges from one end. 3. Lower the output tray, then open the printer cover and the cartridge cover. Press the H ink button again, and reinstall the ink cartridge until it clicks into place. When the ink charging process is finished, the P power light stops flashing and remains on. The ink cartridges packaged with your printer are partly used during initial setup. In order to produce high quality printouts, the print head in your printer will be fully charged with ink. This one-off process consumes a quantity of ink and subsequent cartridge sets will last for their full rated life. 3. . Caution: Be careful not to break the hook on the side of the cartridge when you remove it from the protective bag. Do not shake the ink cartridge after removing from the bag; this can cause leakage. [. . . ] Do not shake the ink cartridge after removing from the bag; this can cause leakage. Do not remove or tear the label on the cartridge; this can cause leakage. Doing so may prevent normal operation and printing. For Macintosh users 1. [. . . ]