User manual EPSON STYLUS PHOTO R265

[. . . ] Follow the Setup utility's on-screen instructions to install the ink cartridges. Note: If the Setup utility does not start, follow the instructions of this sheet, beginning from " Install the ink cartridges. " When ink cartridge installation is complete, proceed to "Load paper and check the print head nozzles" on this sheet. c Caution: Do not move the print head by hand, as this may damage the printer. Note: If the ink end error occurs after the print head moves to its home position, the ink cartridge may not be installed properly. Press the H ink button again, and reinstall the ink cartridge until it clicks into place. When the ink charging process is finished, the P power light stops flashing and remains on. [. . . ] For Macintosh, double-click User Guides. Note: When you access the printer software from a Windows application, the settings that you make apply only to the application you are using. If you are a Windows 2000 user, select your printer, then click Printing Preferences on the File menu. Panel Operation Button Function Turns the printer on and off. To turn the printer off, press and hold the P power button until the light goes out. Clears the memory of the printer if pressed twice while the power is on. Printing will resume if pressed after a paper out error or double feed error. Enables print head cleaning if pressed for three seconds while the H ink out light is off. power If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for this printer. When handling ink cartridges Do not open the ink cartridge packages until just before you install them. Before installing the new ink cartridge, shake it four or five times before opening its package. Do not allow children to drink from or otherwise handle the cartridges. Be careful when you handle used ink cartridges, as there may be some ink remaining around the ink supply port. If ink gets on your skin, wash the area thoroughly with soap and water. See the instructions packed with the media to determine which side is the printable side. The loading capacity varies by model. For more details on using special media, see "Paper Handling" in the online Reference Guide. Load envelopes starting from the short edge with the flap facing to the left. For details on printing envelopes, see "Loading Envelopes" in the online Reference Guide. Replace the ink cartridge with a new one. To determine which cartridge is empty, check the ink level using EPSON Status Monitor 3* or EPSON StatusMonitor*. If the ink end error occurs after the print head moves to its home position, the ink cartridge may not be installed properly. Wrong cartridge The currently installed ink cartridge is not compatible with the printer. Information for United Kingdom Users Use of options EPSON (UK) Limited shall not be liable against any damages or problems arising from the use of any options or consumable products other than those designated as Original EPSON Products or EPSON Approved Products by EPSON (UK) Limited. Refer to the rating plate for the voltage and check that the appliance voltage corresponds to the supply voltage. Important: The wires in the mains lead fitted to this appliance are coloured in accordance with the following code: Green and yellow -- Earth Blue -- Neutral Brown -- Live Use the appropriate ink cartridge. kP km O Carriage error H The print head carriage is obstructed by jammed paper or other foreign material and cannot return to the home position. For Macintosh users EPSON's Technical Support Web Site provides help with problems that cannot be solved using the troubleshooting information in your printer documentation. To access Technical Support, insert the CD in the CD-ROM drive and double-click the Technical Support Web Site icon in the Printer Software folder. For further information on the customer support services available in your area, see the online Reference Guide. Replacing Ink Cartridges You can replace an ink cartridge by using the Status Monitor utility installed on your computer, or by using the printer's control panel. [. . . ] Do not take it apart or try to refill it. When choosing a power source Use only the type of power source indicated on the printer's label. If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. [. . . ]