User manual EPSON EMP-51

[. . . ] When unpacking the projector and accessories from their box, check that the following items are included. If any of the components are missing or incorrect, please contact the place of purchase. Two manganese dry cells for the remote control Getting Started Name and function of each part and of the remote control operation Setup Special notes on setup, setup instructions, and screen size and projection distance details Projecting Images Connecting with different devices and projecting and adjusting images What You Can Do Functions to get the most out of your projector Menu Functions (Remote Control Only) Basic menu functions and settings Troubleshooting Troubleshooting projection failure, bad projection, and other problems Maintenance Performing lamp replacement and other routine maintenance and care General Notes Optional parts, glossary, index, specifications Clear, Sharp Images Though compact, your projector provides clear, sharp presentations even in well-illuminated areas. Global Video Signal Compatibility Your unit projects virtually all of the video signal formats used world-wide, including NTSC, NTSC4. [. . . ] After sleep mode is activated, the projector enters standby mode when no signal is input from an external source for a continuous period of 30 minutes. To reset all menus to factory shipping values, use the Reset All menu. Press the Menu button, use the Enter button to select "Advanced" from the top menu displayed, and press the Enter button to move to a submenu. Use color temperature or RGB to create settings for the colors displayed on screen. This setting is used for projection with the projector hanging from a ceiling. To reset all menus to factory shipping values, use the Reset All menu. Press the Menu button, use the Enter button to select "About" from the top menu displayed, and press the Enter button to move to a submenu. The settings information displayed in the About menu differs as shown below during video projection from a computer/component versus a video device. Press the Menu button, and use the Enter button to select "Reset All" from the top-level menu displayed. (Lamp and language settings excluded) * Note that rear and invert settings will also be cleared by this operation. If you think your projector may have failed, first check the indicators on the unit. Your projector includes an "operation display indicator" and a "problem/alarm display indicator" which provide information on projector status. Steady green Flashing green Projection in progress Warm-up in progress (Not abnormal) (Not abnormal) Please wait. After warm-up is complete, the flashing green indicator changes to steady green. Check that the air inlet and air outlet are clear, and that the projector is not positioned against a wall. After reconnecting the power plug the operating condition is restored. If the projector continues to overheat even after the above points have been checked, or if the indicators show a problem when the power is turned back on, stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package. Flashing red (1-second intervals) Problem with lamp Disconnect the power cord from the electrical outlet, remove the lamp and check if the lamp is broken. If it is not broken, reinstall it and then press the [Power] button on either the remote control or the projector's control panel. If the indicators still show a problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "Safety Instructions/ World-Wide Warranty Terms" included in the package. If the lamp is broken, handle pieces carefully to avoid injury, and contact your dealer or the nearest address provided at "International Warranty Conditions" in "Safety Instructions/World-Wide Warranty Terms" included in the package for repair (video projection is not possible unless the lamp is replaced). If the lamp or lamp cover is not attached securely, follow the replacement instructions to attach it securely. [. . . ] The carrier signal which is contained in the color bar signal used in modern TV transmissions (NTSC format). the name comes from the Y (luminance) signal and the CbCr (chroma [color]) signals. The carrier signal which is contained in the color bar signal used in high-definition TV (HDTV) transmissions. the name comes from the Y (luminance) signal and the PbPr (color difference) signals. [. . . ]