User manual ELECTROLUX LNC7MD32W2

[. . . ] You've chosen a product that brings with it decades of professional experience and innovation. So whenever you use it, you can be safe in the knowledge that you'll get great results every time. Get usage advice, brochures, trouble shooter, service and repair information: www. Com Buy Accessories, Consumables and Original spare parts for your appliance: www. [. . . ] When the ambient temperature returns to normal, you may continue using the appliance as usual. In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in the coldest area. To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK" appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set properly It may be difficult to see the indicator, make sure it is properly lit. Each time the OK Temperature setting device is changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary, with a new temperature setting. Please change the position of the temperature setting device progressively and wait at least 12 hours before starting a new check and potential change. NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance, it is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal build up of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until compressor off periods are obtained again. Your foods will be better stored if you put them in the most appropriate cooling area. To be sure to have a low temperature in this area, make sure the shelf is located at the level of this symbol, as shown in the illustration. The upper limit of the coldest area is indicated by the lower side of the sticker (head of the arrow). The coldest area upper shelf must be at the same level with the arrow head. As these shelves are removable, make sure they are always at the same level with these zone limits described on the stickers, in order to guarantee temperatures in this area. After the water has completely frozen, you can twist the tray as shown below to remove the ice cubes. The Freezer Box The freezer box allows food to be accessed more easily. Pull the box out as far as possible · Pull the front of the box up and out Carry out the opposite of this operation when refitting the sliding compartment. Extra Chill Compartment (In some models) Ideal to preserve the taste and texture of fresh cuts and cheese. The pull out drawer assures an environment with a lower temperature compared to the rest of the fridge, thanks to the active circulation of cold air. Pull the chiller shelf up from the rail and remove it from the fridge. If the crisper is full, the fresh dial located in front of the crisper should be opened. This allows the air in the crisper and the humidity rate to be controlled, to increase the life of food within. The dial, located behind the shelf, must be opened if any condensation is seen on the glass shelf. [. . . ] Fresh Food Compartment (Fridge): Most efficient use of energy is ensured in the configuration with the drawers in the bottom part of the appliance, and shelves evenly distributed, position of door bins does not affect energy consumption. Frozen Compartment (Freezer): The internal configuration of the appliance is the one that Ensures the most efficient use of energy. Do not remove the cold accumulators from the freezer basket (if present. This presentation is only for information about the parts of the appliance. [. . . ]