User manual EINHELL EURO 8

[. . . ] Check the power plug and cable regularly and have them replaced by a specialist if you discover any damage. Pull out the power plug - Whenever the compressor is not being used and before carrying out any maintenance work. Do not leave any tools on the compressor - Before you switch on the compressor, make sure that all wrenches and setting tools have been removed. Avoid accidental starts - Make sure that the switch is turned to OFF before you connect the compressor to the power supply. [. . . ] Safety instructions for working with compressed air and paint sprayers Compressors and lines reach high temperatures during operation. Gases or vapours drawn in by the compressor have to be kept free of constituents that may cause fire or explosions inside the compressor. When you disconnect the hose coupling, hold the coupling element in your hand to prevent injury from the whiplashing hose. Never point the blow-out gun at other persons and never use it to clean clothes that are still being worn. G It is imperative to use filtering equipment (face masks) when processing harmful liquids. Note also the information concerning safety precautions published by the manufacturers of these liquids. G Smoking is prohibited during the spraying operation and in the work room. G The details and designations of the Ordinance on Hazardous Substances, which are displayed on the outer packaging of the processed material, must be observed. G The work room has to be bigger than 30 m3 and have sufficient ventilation for spraying and drying. It is always imperative to observe the regulations of your local police authorities when spraying combustible or hazardous substances. G Never process media such as white petroleum spirit, butyl alcohol and methylene chloride with the PVC pressure hose (reduced life span). Putting the compressor into operation Operation of pressure vessels in accordance with the pertinent pressure vessel regulations 1. An operator of a pressure vessel is required to keep the pressure vessel in good working order, to operate it properly, to supervise its use, to carry out essential maintenance and repair work immediately, and to introduce essential safety measures according to requirements. The supervisory authorities may order essential safeguards from case to case. A pressure vessel may not be operated if it has any defects which constitute a danger to employees or third parties. If you discover any damage, then please contact the customer service workshop. Connecting to the power supply: The compressor is equipped with a power cable and an earthing-pin plug for connection to any 230 V ~ 50 Hz earthing-contact socket outlet with a 16 A fuse. Long supply lines, extensions, cable reels and similar cause voltage dips and may prevent the motor from starting. Sluggishness makes starting difficult at low temperatures under freezing point (0°C). Screw the air filter (1) into the hole in the side of the compressor pump. G Condensation water Let out the condensation water daily by opening the drain valve (bottom of the pressure vessel). G Safety valve The safety valve is set to the maximum pressure of the pressure vessel. [. . . ] Som leder till överbelastning av motorn och därmed till att överbelastningsskyddet slår till: G för hög nätspänning G för höga omgivningstemperaturer och otillräcklig lufttillförsel G defekta kompressorventiler eller otät backventil G min. The undersigned declares in the name of the company that the product is in compliance with the following guidelines and standards. The product described in these instructions comes with a 2 year warranty covering defects. This 2-year warranty period begins with the passing of risk or when the customer receives the product. [. . . ]