User manual EINHELL BT-LS 55

[. . . ] The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. 5. Technical data of the BT-LS 44 Voltage: Power rating: Idle speed: Insulation class: Protection type: Max. [. . . ] Tilt the wood splitter so that the drainage opening (G) faces upwards. Fill the machine with the amount of hydraulic oil required with the help of a clean funnel. (Make sure that you only use clean, high-quality hydraulic oil which is specifically intended for this purpose. ) 5. Clean the oil-level gauge (E) and insert it to check that the oil level is between the two marks (H) on the oil-level gauge. Thoroughly clean the oil-level gauge (E) and the oil seal O-ring (F) and fit them back in place. Recommended hydraulic oil We recommend that you use one of the following makes of hydraulic oil for the hydraulic cylinder: SHELL TELLUS T22 ARAL VITAM Gf22 SP ENGERGOL HCP22 MOBIL DTE11 or an alternative of the same quality NEVER USE ANY OTHER TYPES OF OIL 8. Insert a triangular shaped wooden wedge under the trunk and then start the trunk pusher to press the wedge under the stuck trunk. Repeat this process with larger and larger wedges until the stuck trunk is released. Never hammer against the stuck trunk or place your hands anywhere near the trunk when trying to release it. NEVER ASK ANYONE ELSE TO HELP WHEN TRYING TO RELEASE A TRUNK WHICH HAS BECOME STUCK. Once it has been in use for some time, or as and when necessary, you should sharpen the wedge with a fine-toothed file and carefully remove any burrs or flat areas on the edge. Always disconnect the device from the power supply before starting any maintenance work! 11. Motor circuit breaker switch (Fig. 20 / Item B) If the motor is overloaded for a longer period the motor circuit breaker switch will shut off the power supply automatically. This can be reset by pressing it in after waiting approximately 1 minute. The wood splitter will then be ready for use again. 12. Pressure control valve (Fig. 14 / Item A) The pressure control valve was set correctly at the factory and must never be adjusted. 10. Changing the hydraulic oil (Fig. 22-25) The hydraulic oil should be changed after every 300 hours of operation. 16 Anleitung BT_LS_44-BT_LS_55_SPK1:_ 04. 09. 2007 13:02 Uhr Seite 17 GB 13. Ordering replacement parts Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 17 Anleitung BT_LS_44-BT_LS_55_SPK1:_ 04. 09. 2007 13:02 Uhr Seite 18 GB 14. Troubleshooting The following table describes the possible problems which may arise when you use the wood splitter and provides recommended remedial measures for dealing with them. Problem Motor fails to start Probable cause Motor circuit breaker has been triggered Trunk is incorrectly positioned Trunk exceeds permitted dimensions Wedge fails to cut Remedy Allow the motor to cool down and press in the motor circuit breaker switch Position the trunk correctly Reduce the size of the trunk Trunk fails to split Sharpen the wedge. Remove burrs and nicks from the wedge Contact an authorized dealer Contact an authorized dealer Check the oil level. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]