User manual EINHELL BT-AC 210-24

[. . . ] Extension cables for outdoor use - Use extension cables outdoors only if they are approved and marked accordingly. Examine your compressor for signs of damage - Before you use the compressor again, carefully check its safety devices or any slightly damaged parts to make sure that they are working properly and as intended. Check moving parts to make sure that they are in good working order and are not jammed or damaged. All parts have to be properly fitted in order to be sure of meeting all the machines requirements. [. . . ] You must fully assemble the appliance before using it for the first time. Power supply: Motor rating in kW/HP: Operating mode Compressor speed in rpm: Operating pressure in bar: Pressure vessel volume in litre: Theoretical intake rate in l/min. : Sound power level LWA in dB: Sound pressure level LpA in dB: Protection type: Machine weight in kg: 230 ~ 50 Hz 1. Fitting the air filter (1) Remove the transportation stop with a screwdriver or similar and screw the air filter (1) securely to the equipment. Replacing the oil sealing plug (14) Remove the transportation cover from the oil filler opening with a screwdriver and insert the supplied oil dipstick (14) into the oil filler opening. 5 Voltage The compressor is equipped with a mains cable with shock-proof plug. This can be connected to any 230V ~ 50Hz shock-proof socket which is protected by a 16 A fuse. Before you use the machine, make sure that the mains voltage complies with the specifications on the rating plate. In the case of low temperatures below +5°C, motor start-up is jeopardized as a result of stiffness. Operating mode S3 - 25% - 10min: S3 = Intermittent mode without influencing the starting process. Report any damage immediately to the company which delivered the compressor. 1) You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7). 8 Setting the pressure switch The pressure switch is set at the factory. 3 Safety valve (10) The safety valve has been set for the highest permitted pressure of the pressure vessel. Actuate the safety valve from time to time to ensure that it works when required. Pull the ring with sufficient force until you can hear the compressed air being released. 4 Check the oil level at regular intervals Place the compressor on a level and straight surface. Screw the dipstick back into the filler opening as far as it will go, screw out again and hold it horizontally to read off the oil level. The oil level must be between the two marks MAX and MIN on the oil dipstick (Fig. It should be refilled for the first time after 100 hours of operation. Thereafter the oil should be drained and refilled after every 500 hours in service. 5 Changing the oil Switch off the engine and pull the mains plug out of the socket. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]