User manual EINHELL BG-WW 636

[. . . ] The manufacturers warranty does not cover damage caused to the equipment as a result of running it dry. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. In stagnant water bodies, garden ponds, swimming ponds and their surrounding areas the unit may only be used with an earth-leakage circuit breaker with an actuating rated current of up to 30 mA (according to VDE 0100 Part 702 and 738). [. . . ] With the right couplings it is also possible, of course, to use a 1/2" delivery hose. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. The intake process starts automatically; water can be suctioned in for up to 5 minutes (maximum suction height). The equipment will shut down when the cut-out pressure of 3 bar is reached. After a loss of pressure due to water consumption the equipment will cut in again automatically (cut-in pressure approx. Important: Be sure to completely empty the water bag first using the water drain screw (2). Replacing the mains cable: Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. There are no parts inside the equipment which require additional maintenance. 2 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. After long stoppages, make sure the rotor turns correctly by briefly switching the pump on and off. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. In order to ensure a long service life, however, we recommend that you regularly check and care for the product. The equipment must be disconnected from the power supply (pull the power plug) prior to performing any maintenance. 1 Servicing If the equipment becomes clogged, connect the discharge line to the water line and disconnect the suction hose. Inside the pressure tank is an expandable water sack and an air compartment whose maximum pressure should lie at approx. Pumping water into the water sack causes the sack to expand so that the pressure in the air compartment rises to switch-off level. To do so, unscrew the plastic lid from the tank and top up the pressure to the correct level using a tyre The unit is supplied in packaging to prevent its being damaged in transit. [. . . ] Consequently, the guarantee is invalidated if the equipment is used in commercial, trade or industrial applications or for other equivalent activities. The following are also excluded from our guarantee: compensation for transport damage, damage caused by failure to comply with the installation/assembly instructions or damage caused by unprofessional installation, failure to comply with the operating instructions (e. Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. [. . . ]