User manual E-TEN M500

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual E-TEN M500. We hope that this E-TEN M500 user guide will be useful to you.

E-TEN M500 : Download the complete user guide (1967 Ko)

You may also download the following manuals related to this product:

   E-TEN M500 (6756 ko)
   E-TEN M500 (6668 ko)
   E-TEN M500 (6629 ko)
   E-TEN M500 (6608 ko)
   E-TEN M500 (6380 ko)

Manual abstract: user guide E-TEN M500

Detailed instructions for use are in the User's Guide.

 [. . . ] \ Infrared Part /
Installing and Setuping the Virtual Modem
This section explains how to use the Pocket PC to simulate a Wireless Modem. After connecting successfully to the desktop computer through the infrared (IR) device,  you can use the desktop computer to perform tasks,  such as connecting to a network,  etc. 

PC System Requirements 1. Personal computer side:
(1)

Use the Internet to download and install the PC driver program.  [. . . ] After your Pocket PC connecting successfully to the desktop computer,  you can use the desktop computer to perform tasks,  such as connecting to the network,  etc. 

Refer to the following explanation to set up a virtual COM port. Select a virtual COM port,  it is prepared for the Infrared port. 

4

Refer to the following explanation to set up. Select the Image Transfer tab,  confirm not to check "Use Wireless Link to transfer images from a digital camera to your computer. "

5

Refer to the following explanation to set up a virtual modem. Select the Modems tab and then click Add to add a new virtual modem. 

3. Check "Don't detect my modem; I will select it from a list, " and then click Next. 

4. Select "Standard 33600 bps Modem, " and then click Next. 

6

5. Select the same COM port you selected earlier using the IrCOMM2k setup program,  and then click Next. 

6. You have set up a virtual modem successfully. 

7

Refer to the following explanation to set up properties of the virtual modem. Select the Modems tab and select the virtual modem you have just set up,  and then click Properties. Select the Advanced tab and input "AT+CGDCONT=1, "I P", "APN", "", 0, 0". Change the "APN" to the name specified by your telecom company. Finally,  click OK to complete and exit Phone and Modem Options. 

8

Refer to the following explanation to establish a new connection. Click ,  Settings, 

Control Panel,  Network and Dial-up Connections,  and then Make New Connection. Select "Dial-up to the Internet, " and then click Next. 

4.  [. . . ] Select the General tab to confirm that you have selected the virtual modem you have just set up and click Configure. 

12

4. Do not check the following items:
Enable hardware flow control Enable modem error control Enable modem compression Enable modem speaker

Finally click OK to save. Select the Networking tab and confirm that you have selected "Internet Protocol (TCP/IP), " and click Properties. 

6.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE E-TEN M500

Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual E-TEN M500 will begin.