User manual E-PIL PAGER2

[. . . ] TNC will repair or replace the product under the limited warranty within 15 days after receipt of the product by TNC. TNC shall not be liable for special, incidental or consequential damages, including but not limited to, loss of anticipated benefits or profits, loss of savings or revenue, punitive damages, loss of use of the product or any associated equipment, cost of capital, cost of any substitute equipment, downtime, the claims of any third parties including customers, and injury to property, resulting from the purchase or use of the product or arising from breach of the warranty, breach of contract, negligence, strict tort, or any other legal or equitable theory, even if TNC knew of the likelihood of such damages. TNC shall not be liable for delay in rendering service under the limited warranty, or loss of use during the period that the product is being repaired. Your Vibrating Pager Reminder has a switch on the side labeled B O V. This switch is used to make the Vibrating Pager Reminder Vibrate (V), Beep (B) or turn off the alerts Off (O). [. . . ] The Vibrating Pager Reminder is perfect for people with attention deficit disorders (ADD/ADHD), memory problems, or people who have a hard time hearing an audio alarm. Excellent for psychotherapists, counselors, MD's, lawyers, accountants, masseuses, physical trainers, physical therapists, business people, teachers, speakers, chiropractors, chefs, lab personnel, shop workers. . . . Display TIME DATE TIMER SET Alarm Switch V = vibration O = off B = beep Lite: Press once and stays on for 12 seconds Mode button Enter button Mode Enter Set Lite To Exit from Timer and Meeting Timer modes push simultaneously, then press Mode button to exit Set button Hold down for rapid counting 4 e-pill® Vibrating 12 Alarm Pager | www. epill. com e-pill® Vibrating 12 Alarm Pager | www. epill. com 17 NOTES: Operating Modes Your Vibrating Pager Reminder has seven operating modes (accessed by the Mode button) as described on the following pages. Vibration and Beep adjustment (VIB & BEEP): Use to adjust Vibration Speed (1 = low, 2 = medium, 3 = high), Beep Volume (1-3), Number of beeps (1-6). 12 Alarms (ALARMS SET): Use to set up to 12 alarms in a 24-hour period. Alarms programmed in this mode will signal no matter what other mode the unit is in. Timer (TIMER SET): Use for simple timing or to repeat a time over and over. Custom Timer (CUSTOM TMR): Use to set any countdown time of up to 60 minutes, and program with up to six custom alerts to go off at any time in this period. Meeting Timer (MEET-TIMER): Use for meetings, presentations or to track time during any interval. The Meeting Timer vibrates at ½ way, at 5 minutes before time's up, and at time's up, for any time interval set between 10 ­120 min. Stopwatch (STOP-WATCH): use to count time for any event. Setting Protection: ( Setting protection engage automatically) To protect the Timer, Meeting Timer and Custom Timer settings from erasure by accidental button presses, the Vibrating Pager Reminder has a "button auto-lock" feature (which engages automatically). To exit from the Timer or Meeting Timer you have to press the two middle buttons simultaneously, and then press the Mode button to exit. To exit from the Custom Timer you only have to press and hold the two middle buttons simultaneously for 2 seconds. 16 e-pill® Vibrating 12 Alarm Pager | www. epill. com e-pill® Vibrating 12 Alarm Pager | www. epill. com 5 The e-pill Vibrating Pager Reminder will automatically adjust the time for daylight savings time; please see details below on how to turn this feature on or off). Time, Date and Daylight Saving Settings Q&A e-pill Vibrating 12 Alarm Pager 1. When do I change the Battery: The battery is low when the backlight becomes dim and the vibration is noticeably slower / or the beep volume is lower. The e-pill Vibrating 12 Alarm Pager will retain your programming for a short time (30 seconds to 1 minute) while you change your battery. 6 e-pill® Vibrating 12 Alarm Pager | www. epill. com e-pill® Vibrating 12 Alarm Pager | www. epill. com 15 MEETING TIMER NOTES: 1. Once a meeting time is started, it will repeat every 1/2 hour for durations of 10-30 minutes, and repeat every hour for durations of 31-60 minutes, and repeat every other hour for durations of 61-120 minutes. For example, program a meeting time of 50 minutes and start it on the hour, it will go for 50 minutes, wait 10 minutes and then begin again on the next hour. If you start this 50 minute meeting time at 10 minutes after the hour, it will go for 50 minutes, wait 10 minutes and begin again at 10 minutes after the next hour. Meeting times of 30, 60, 120 minutes will repeat back to back automatically. For all other meeting times, there will be a space before the meeting timer repeats. For example, for a meeting time of 25 minutes, it will go for 25 minutes, wait 5 minutes and begin again. For a meeting time of 40 minutes it will go for 40 minutes, wait 20 minutes and begin again. [. . . ] The countdown time period can be set to countdown once, or set to repeat over and over, or set for a count-up after countdown is finished (so you can see how much time has elapsed since countdown completed). 12 e-pill® Vibrating 12 Alarm Pager | www. epill. com e-pill® Vibrating 12 Alarm Pager | www. epill. com 9 Stop Countdown Set Alert B the same way as you set A. TIP: To skip an After setting the alert during proalerts you want, gramming, press proceed to the Enter button STEP 3 below. two times. This action stops the timer and puts it in the ready position to Press two middle buttons simultaneously for 1 second start again or less to stop countdown C-UP : 20 : 00 pm2:33 CTMR Restart Then countdown pm2:33 CTMR C-UP : 19 : 49 Exit Mode pm2:33 8-13 CUSTOM TMR Press to restart countdown Press two middle buttons simultaneously and hold for 2 seconds to exit mode Alert A = 5 second vibration. . . or if alert switch (on the side of the unit) is set to beep = 1 beep Alert B = 5 second vibration, 5 second space, 5 second vibration. . . . . . . . . . . . or. . . . . . . . . . . [. . . ]