User manual DREMEL 275

[. . . ] Lay the guide flat on the tooth with the 30º index line parallel with the chain. Repeat the process above to sharpen all of the cutter teeth on the far side of the chain. After your chain has been sharpened a number of times, you may find that it does not cut as fast as you feel it should. Each cutter on your chain has a depth gauge (D) just ahead of the cutting edge (C) that determines how big a bite it can take. [. . . ] This dimension should be approximately equal to the thickness of the gauge (D). If it is not, grind the chain depth gauge until the clearance is approximately equal to the thickness of the sharpening kit gauge. Keep this depth gauge setting uniform on all cutter teeth to make straight cuts. This DREMEL product is guaranteed in accordance with statutory/country-specific regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. In case of a complaint, send the tool undismantled together with proof of purchase to your dealer. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. According the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its implementation into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally correct manner. Depending on your particular chain size, make sure you assemble your new sharpener properly as follows: Disconnect the plug from the power source before making any Preventive safety measures reduce the risk of starting the power tool accidentally. When you have determined the correct grinding stone for your chain from the drawing, assemble the attachment by screwing the guide (B) and appropriate number of spacers (C) to the clamp (D) using the two screws (A), as shown in Figure 2. Securely mount the correct grinding stone in your tool with approximately 6 mm of the shank exposed between the chuck cap and the stone (Figure 3). Remove the housing cap and screw on the chain saw sharpening attachment (Figure 4). Using the appropriate side of the gauge (A), adjust the guide so it is properly positioned with respect to the grinding stone and tighten the screws. The gauge must be flush with the corner (B) of the guide while making contact with the grinding stone (Figure 5). [. . . ] Please read and understand these instructions and the chain saw manual for complete details for sharpening. When attached to a Dremel rotary tool, the chain saw sharpening attachment will sharpen nearly all common sizes of chain if you follow these simple instructions. For proper sharpening the chain tension should be adjusted (as specified in the Chain Saw Owner's Manual). Sharpening will be best accomplished if done on the flat of the saw bar ­ somewhere near the middle of the bar. [. . . ]