User manual DOMOLINE GS200

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. [. . . ] 1-A). A 45° D060 Appliance positioned without overhanging kitchen units (see Fig. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. Fig. 1 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. min. 2 50 cm A B The Manufacturer declines all responsibility if the above safety precautions are not observed. 87/308 of 2/6/87 concerning the suppression of radio interference. min. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 13 Door reversal (Fig. To reverse the door, proceed as follows: dismantle the lower hinge (3), pin (1), the threaded insert (4) and the screw (2); slide the door out from pin (5), unscrew the pin and reposition on the opposite side; unscrew the left front foot and reposition on the opposite side; unscrew the two screws which mask the holes for fixing the hinge from the left front side; reassemble the door; reassemble the lower hinge (turning it 180°), the threaded insert, the pin and the screw on the opposite side, as shown in the figure; dismantle the handle (6) and reassemble it on the opposite side. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. 4 3 6 5 Fig. 3 1 ° 80 2 1 D193 14 USING YOUR FREEZER This freezer has been marked with the symbol, which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. The control panel 6 5 4 3 1 2 NS S A Fig. Temperature alarm light Starting Insert the power supply plug into the nearest wall socket (the function indicator light (C) will light up indicating that the freezer is receiving electrical input). Turn the thermostat knob (A) to the right to a medium setting (the temperature alarm light (E) will light up). For the satisfactory conservation of frozen foods, the freezer's internal temperature must be lower than ­ 18°C. Wait until the temperature alarm light (E) turns off when the optimum temperature has been reached. Thermostat settings may be modified according to the surrounding room temperature, the location of the freezer and the frequency of door openings, etc. To turn off the freezer, turn the thermostat knob to the «O» position. Quick-freezing For quick-freezing, turn the N/S knob (B) to the «S» symbol. The quick-freezing indicator light (D) will then light up. The temperature alarm light (E) The temperature alarm light turns on automatically whenever the temperature within the freezer rises above a certain value which might endanger satisfactory long-term conservation. [. . . ] Frozen products which come in small-sized or separate packages may be cooked directly without thawing; obviously, in this case, the cooking time will last a little longer. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water to 3/4 of their height, then put them in the freezer. The ice-cubes may be shaken out from the trays by simply twisting; do not use metallic instruments to remove the trays from the freezer. 17 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Idle periods During periods when the appliance is not used, you should take the following precautions: remove the plug from the wall socket; remove all food from the appliance; defrost and clean the interior and all accessories; leave the door slightly open, thus letting air circulate and preventing the formation of mould and unpleasant smells. Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. [. . . ]