User manual DAHON TIAGRA ST-4500 TECHNICAL SERVICE INSTRUCTIONS
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DAHON TIAGRA ST-4500. We hope that this DAHON TIAGRA ST-4500 user guide will be useful to you.
Manual abstract: user guide DAHON TIAGRA ST-4500TECHNICAL SERVICE INSTRUCTIONS
Detailed instructions for use are in the User's Guide.
[. . . ] Pull the bracket cover back and use a 5 mm Allen key to tighten the bolt.
Lever F B
Bracket cover
Installing the shifting cable
Cable used
· Inner cable (stainless steel)
· Outer stopper 1. Install the outer stopper to the down tube.
f 1. 2 mm
Outer stopper Adjustment bolt
· SP41 sealed outer casing (/)
5 mm Allen key
f 4 mm
SP41
SEALED
Installation bolt 3mm Allen key
Note
· Operation of the levers related to gear shifting should be made only when the front chainwheel is turning. [. . . ] Gears will not shift when both levers are B pressed simultaneously.
Be sure to read these service instructions in conjunction with the service instructions for the RD-4500 before use.
2. Pass the inner cable through, and set the outer casing.
Be sure leave some excess in the outer casing, even if cutting it to the full length of the handlebars.
· SLR outer casing
Be sure to leave some excess cable, even if cutting it to the full length of the handlebars.
When cutting the outer casing, cut the opposite end to the end with the marking. After cutting the outer casing, make the end round so that the inside of the hole has a uniform diameter.
1. Tilt the lever in (as when shifting) to make it easier to pass the cable through the cable hook.
Note: The front lever cannot be tilted to the inside until lever F is pushed b once or twice.
Attach the same outer end cap to the cut end of the outer casing.
Outer stopper Outer end cap. Inner cable Outer casing
Anatomic type
Round type
ST-4500 Reach adjustment
If you would like to reduce the reach, remove the bump rubber and replace it with the accessory pad spacer. (Two types are available: 4° and 8°. )
Pad spacer
Technical Service Instructions
SI-6LP0A
· Rear lever
Operation of front derailleur levers
(FD-4500 / 4503)
· Lever F : Shifts from smaller to larger front chainring. a Pull Tilt
Lever F b
ST-4500
Shimano Total Integration
Operate lever F 8 or more times B to set the lever to the highest position, check on the indicator that the highest position is correct, and then install and adjust the inner cable.
Confirm
B Lever F
Operate at least 8 times
Make sure the outer casing is firmly seated in the outer stopper.
2. Pass the inner cable through.
Cable hook
Lever F a Lever F a
Replacement method
start position
Depress the brake lever, and then pass the inner cable through the cable hole.
Inner cable
Cable hole
Replacing the bracket cover
The tabs on the bracket cover each fit to a matching slot on the bracket.
If operation of lever a does not complete the chainring shift stroke, operate lever a again for the distance (X') to complete that part of the lever stroke (X) which was short.
Full gear shift stroke Actual stroke
1. Apply a thin layer of grease to the two projections of the pad spacer. Press-fit the pad spacer so that the projections go as far in as possible. [. . . ] Make sure that the inner end is firmly seated in the cable hook.
Cable hook
Caution on operation (FD-4500 / 4503) Lever F will also move when lever F is operated, b a but be careful not to apply pressure to lever F. Gears will not shift when both levers b are pressed simultaneously.
Movement of the front derailleur
Tape Outer casing
These service instructions are printed on recycled paper.
Lever Lever Lever Lever
F : Shifts from smaller to larger rear sprocket. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DAHON TIAGRA ST-4500
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DAHON TIAGRA ST-4500 will begin.