User manual CME GPP-3

[. . . ] This product, either alone or in combination with an amplifier and headphones or speaker(s), may be capable of producing sound levels that could cause permanent hearing loss. Do NOT operate for long periods of time at a high volume level or at a level that is uncomfortable. If you experience any hearing loss or ringing in the ears, you should consult an audiologist. IMPORTANT: The louder the sound, the shorter the time period before damage occurs. [. . . ] The above statements apply ONLY to those products distributed in the USA. 4 PRECAUTIONS IMPORTANT Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, damages, fire or other hazards. Before cleaning the instrument, always remove the electric plug from the outlet as well as the USB cable. Do not use gasoline, alcohol, acetone, turps or any other organic solutions; do not use liquid cleaner, spray cleaner or too wet cloth. Do not use the instrument near water or moisture, such as bathtub, washbasin, washing poor in the kitchen or similar places. Do not place the instrument in an unstable position where it might accidentally fall over. Do not jam sinks or holes of the instrument; those sinks of holes are used for air circulation to prevent the instrument from overheating. Do not place the instrument near heat sink or any places with poor air circulation. Make sure the power cord is set on a safe place, so nobody will step on it and no body will trip over it. Do not overload the outlet and the AC cable to avoid fire or electrical shock. Do not insert anything in the instrument, which may cause fire or electrical shock. Do not disassemble the instrument in case of accidental electrical shock. Always take the instrument to a qualified service center in need of repair. You will cause yourself in danger if you open or remove the cover, and improper assembly may cause electrical shock in the future use. Unplug all the connectors and take the instrument to a qualified service center if anything in the below listed happens: A. The instrument dose not work properly after following all the instructions regarding to the trouble shootings. Do not use the instrument when thundering; otherwise the thundering may cause long-distance electrical shock. Keep this manual in safe place CAUTION: 5 Setting up Do not connect the instrument when thundering. Do not set up the cord or outlet to a moist place, except for that the outlet is specially designed for moist places. When the power cord is connected to the AC outlet, do not touch the naked part of the cord or the connector. Always follow the instructions carefully when setting up the instrument. WARNING: Do not expose the instrument to rain or moisture, to avoid fire or electrical shock. Other precautions: Keep the instrument away from electrical interface sources, such as fluorescent light and electrical motors. Do not place heavy objects on the instrument; do not place containers with liquid on the instrument. is not responsible for any damage or data loss caused by improper operation to the instrument. [. . . ] After you finished the controller# assigning for a pedal and no pedal is depressed for 3 seconds, you will enter the MIDI channel assigning mode for the same pedal, that the LED is on. Each time you depress the pedal, the MIDI channel value will increase by one from 0-15, which means channel 1-16, and the corresponded LED will flash once. If no pedal is depressed for 3 seconds, the product will save the new settings and return to the normal power on mode. 13 5 Controller list Controller# 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 Controller name Bank Select Modulation wheel Breath control Undefined Foot controller Portamento time Data Entry Channel Volume Balance Undefined Pan Expression Effect control 1 Effect control 2 Undefined Undefined General Purpose #1 General Purpose #2 General Purpose #3 General Purpose #4 Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Bank Select Modulation wheel Breath control Undefined Foot controller Portamento time Data entry Channel Volume Balance Undefined Pan 14 Data type Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Controller Data range 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 0-127 Controller# 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 Controller name Expression Effect control 1 Effect control 2 Undefined Undefined General Purpose #1 General Purpose #2 General Purpose #3 General Purpose #4 Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Undefined Damper pedal Portamento on/off Sustenuto on/off Soft pedal on/off Legato Footswitch Hold 2 Sound Variation Timbre/Harmonic Intens. Release Time Attack Time Brightness Decay Time Vibrato Rate) Vibrato Depth Vibrato Delay Sound Cont. [. . . ]