User manual CAT EYE CC-7000

[. . . ] The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. Install the computer on the stem, with its bottom surface facing the sensor. (Take into account the angle of the stem. ) Interference may occur, resulting in malfunction, if the computer is: · Near a TV, PC, radio, motor, or in a car or train. [. . . ] · Close to a second bicycle with wireless sensors. #169-6570 Bracket kit Correct installation of sensor and magnet #169-9691 Wheel Magnet A Attach the magnet 3 so that it passes through the sensor zone of the sensor 2. B Be sure to have a 5 mm-or-less clearance between the sensor 2 and magnet 3. Replacing the Battery · Computer If the Wheel Size icon ( or ) flashes, replace the battery. Install a new lithium battery (CR2032) with the (+) side facing upward. Then re-start the computer according to the SETTING procedure, and then set the clock from the MENU FLOW. Then check the positions of the battery and magnet. #166-5150 Lithium Battery (CR2032) Part names A Current Speed B Sensor signal reception icon Flashes in sync with sensor signals. C Sub measurement icon D Pace arrow Indicates whether the current speed is faster or slower than the average speed. ( Faster Slower) E Auto mode icon F Specification Battery . . . . . . . . . . . . . Computer: Lithium Battery CR2032 X 1 Sensor: Lithium Battery CR2032 X 1 Battery Life . . . . . . 1 year (If the computer is used for 1 hour/day without the backlight on) Sensor: until Total Distance reaches about 10, 000 km (6, 250 mile) *This is the average figure of being used under 20°C temperature and the dis tance between the computer and the sensor is 65 cm. * If the backlight is used frequently, the battery life diminishes accordingly. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co. , Ltd. May void the user's authority to operate the equipment. LIMITED WARRANTY - 2-Year Computer/Sensor only Resetting data . . . . . . . . . . . . . . . . . . . . . . . . . . . Main : c Sub : d To reset measurement data, display the Main/Sub measurement data and press the START/STOP and MODE buttons simultaneously. 2-8-25, Kuwazu, Higashi Sumiyoshiku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Backlight Press the backlight button to illuminate the display for 3 seconds. If the battery is low, the wheel size icon flashes and the display does not illuminate. Service & Research Address for USA CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302 Phone: 303. 443. 4595 Toll Free: 800. 5CATEYE Fax: 303. 473. 0006 E-mail: service@cateye. com URL: http://www. cateye. com Power-saving function If the computer has not received a signal for 10 minutes, powersaving mode will activate and only the clock will be displayed. When the computer receives a sensor signal again, the measuring screen reappears. If two weeks' inactivity elapses, power-saving mode will change to SLEEP mode. [. . . ] If two weeks' inactivity elapses, power-saving mode will change to SLEEP mode. Pressing the MODE or START/STOP button in SLEEP mode brings up the measuring screen. Dual Wheel Size Two wheel sizes (Wheel sizes and ) can be registered on the computer. This is useful when the computer is shared between two bicycles or when one bicycle uses different wheel sizes at different times. [. . . ]